Pump Setup:

Chris1313 Dual 450 Walbro fuel pumps setup with plug and play harness for 2009-2014 Cadillac CTSV Gen 2. This is a direct drop in system that uses the stock plastic tank.  System uses 2 450LPH walbro e85 compatible pumps (capable of 525/535 pumps for $50 adder each).  These support 1000-1200RWHP on e85.  Full anodized aluminum or stainless hardware throughout.  Level sensor and float swaps over from stock onto bracket.  The rest is plug and play with the factory wiring...-10AN -8AN or -6AN your choice of fittings. (if not specified Feed will be -8 and Return will be -6).  You will need to run aftermarket fuel lines (AN), inline filter and adjustable external regulator.  Stock venturi works as stock does for other side of the hump tank.  I kick the pumps 9" farther back in the tank to help with starvation issues other setups have.  Customers have reported doing WOT pulls with 1/8 of a tank with no issues.  (I obviously recommend not pushing it that low but can be done)

Hotwire kit:

10 ga Hotwire for pumps to alternator/battery using 2 - 40AMP weatherproof relays.

Just plug into the stock wiring harness and then into the fuel system sender and you are good to go.

A hot wire kit is a must as these pumps draw more amps than stock.  Stock wiring cannot handle the amp draw.

Send me message also on ls1tech or FB name (Chris1313 Racing Inc) is the same as it is here can save some money outside of the auction.

***Can also supply a complete lines kit with Aeromotive regulator, 10-micron microglass filter, and fittings.  This is adder please message if interested. ***