For connoisseurs

Heater that is also started by the Webasto Thermo Test (WTT) Diagnostic Program on the W-Bus option.

W-bus module S-30R, for  stoves

With it, you start your stove via w-bus and it becomes autonomous.

The controller is started with "On" and turned off with "Off"

Remote control distance 70m(Direct visibility)

Cleans up accumulated errors without needing interfaces

diagnostics or go to a service center.

-press the button for 3 seconds and the errors are cleared.

Led indication:

-constant light -in standby

-blinking light -w bus module started

An increase in  digital stoves may begin.

TTC-MERCEDES, TOUAREG, WV T5, MAZDA 62008 , AUDI Q7, BMW

TTV-WV TOURAN, PASSAT, GOLF V, CADDY, Land Rover 2006-2010).

TTVEVO

TTEVO 2017

and other.

The W-BUS module is an analog signal to digital converter based on W-Bus and is designed to work with stoves:

Webasto Thermo Top V

Thermo Top EVO

Thermo Top C.

The controller activates the stove in autonomous mode without the need for the car computer.

Power supply: 12 v.

Protection included in reverse polarity supply.

W-Bus module

LED indicator 

Dimensions: 50 x 30 mm.

The set contains:

W-bus module S30-R-1pcs

Remote -1pcs

Instruction:

There is no + 12V applied to START and the RESET button is not pressed, then the LED should just light up.

Error reset.

If RESET is pressed for about 3 seconds, the LED flashes FAST during error clearing.  And after cleaning the LED, it lights up without blinking.

Enable WTT.

It is necessary to supply constant voltage + 12V to START.  The pump and stove will start.  The LED should blink SLOWLY.  If you remove the constant voltage + 12V to START, then the stove will stop and the pump will continue to work for 2 minutes.  At the same time the LED should flash FAST.

At the end of the work, the LED lights up continuously.