******  Last ones I'm selling. Closing up shop after these sell.  Going to travel and enjoy life. Get them while they last. ******

If you had to remove your old Wrangler condenser you probably ruined the original rubber mounting hardware.  After searching for myself to find replacement rubber mounts with the correct attaching hardware with no luck, I put this kit together.  Trying to mount it with bolts and nuts is not only wrong but very difficult due to the placement.  Let's also mention the reason there is a rubber isolator in there as well, AC condensers do not like vibrations.  So, I sourced this kit to replace the factory ones.  Simply slide them in between the frame and the condenser and fasten the condenser down snugly until the rubber expands and the lock washer is flat. 

Do not over tighten! The grommets will not completely tighten nor where they intended to do so.  The grommets were intended to snuggly hold the condenser in place and allow rubber isolation between the condenser and the frame.  They can be over tightened and the nut pulled through the rubber.

Each kit contains four rubber mounting grommets and hardware needed to mount the condenser. All in one little bag ready to mount up.

The shipping is expensive.  I am sorry about that.  I have gone round and round with USP but this is the cheapest I can ship them with a tracking number. I know, it's ridiculous. 

May fit other Wrangler models as well. Should work on any model with a 1/2" condenser mounting hole.

I don't fiddle with returns.  Remember the shipping is already high.  Make sure they will work for you.  Be sure to not over tighten.  They are rubber after all.  Snug to where the lock washer is flat is all it takes.

I can say they worked perfectly for my 2000 Jeep Wrangler condenser.