5HP VFD NEMA 1 480VAC The HVFDSB3C0050G130 is a five horsepower, variable-frequency drive (VFD) featuring free-field cooling. It provides proportional control for V/Hz applications up to 3 HP, and can be connected to NEMA 1 IEC motors of 1, 2, 3, or 5 HP nominal voltage with phase rotation between 0o and 180o. The PowerDrive VFD-c3 is a line voltage variable-frequency drive (VFD) that can be mounted in a NEMA 1 (IP65) enclosure for critical control applications. The power and speed of the driver are independently controlled via a step/direction interface. Its compact size and superior motor response time make it ideal for applications requiring small footprint, high efficiency, or impulse starts. The HVFDSB3C0050G130 Power Series™ VFD is designed for a wide range of industrial HVAC/R applications requiring compact design, including small fancoil units. Max power is 5 HP and 3.53 VA. Features include Active boost current limiter, Speed ramp-rate control, Synchronous rectifier for quiet AC operation, Overload protection, Under-voltage protection, Frequency floating software for ultimate speed accuracy, and Unlimited cycling capability The HVFDSB3 series is Honeywell's smallest, lightest, most powerful standard VFD for AC induction motors ranging from 0.5 to 5 horsepower. The cooling system is the advanced centrifugal blower type with integrated fan dynamics control that provides optimum motor cooling along with reduced energy consumption and noise levels. For added reliability in the toughest applications, these VFDs are certified to UL and CSA standards for industrial environments (NEMA 4X). The Honeywell HVFDSB3C0050G130 Variable Frequency Drive (VFD) is an AC motor speed control which can operate a single phase motor between 3.4HP and 17.5hp with full variable speed control from 30 RPM to 2,400 RPM on both the forward and reverse directions (230/460 volts). The HVFDSB3C0050G130 is an AC motor driver that operates in fixed or variable speed and uses a 5.0 HP rotor with a ground start capacitor. The HVFDSB3C0050G130 is a non-reversing controller designed for the following NEMA Enclosure Types: 1 fan cooled (b3 type only), 3 open drip proof, 4 open conduit, 5 open explosion proof and 6 open dust proof. This product is ruggedized for use in food preparation and other applications requiring heavy duty operation. This 3 speed VFD gives you the variety to choose the best speed for the application you are operating, so you can get the job done right. From a range of soft start speeds to high-torque output, this motor has you covered in any condition. This product has been tested and validated on Honeywell equipment to ensure it will work with your unit.