MUFC Devil decal sticker in red adhesive vinyl.

The decal is approximately 3 1/2 inches or 8.75cm

I can also do custom sizes, designs and other colour options made to order. Please send a message if you have any ideas for a decal.

Installation instructions:

For best results, apply to a smooth, shiny, flat surface.

1: Clean the surface

Clean the application surface and let it dry completely. It should be clean, smooth, and dust-free before proceeding to the second step.

2: Peel off the backing

Carefully peel off the paper backing to make sure the vinyl is completely stuck to the transfer tape.

Remove the transfer tape and decal from the backing.

Slowly remove the tape from the backing while making sure that the decal does not stick to the backing. If the decal does stick, use a Scraper Tool for Vinyl or a credit card to apply pressure to the decal until it comes away from the backing paper and sticks to the transfer tape.

3: Align and press

Align the decal and carefully place the decal on the surface.

For precise application, measure and mark the position you want before placing the decal.

Once you are satisfied with the placement, apply the decal. Carefully align the sticker from the top, and then slowly lower it until it lays flat on your surface. If you perform this step in a hurry, you may end up forming bubbles or even wrinkles on the vinyl. Press the tape with your finger to start the application.

4: Smooth

Use a Scraper Tool for Vinyl or a credit card to smooth the design from top to bottom on the surface to push out any bubbles or wrinkles ensure that the vinyl sticks firmly to the surface.

5: Remove the transfer tape

Starting from a corner, slowly pull the transfer tape off your surface. Be careful not to lift part of the vinyl design. If it sticks to the transfer tape, put the tape back on the surface and use the credit card again to apply pressure until the vinyl decal sticks.