1. Cut through with one knife, then shake out the saw blade, move to the next position on the track, cut through again, and repeat the operation. This cutting is the most correct cutting method, without damage to the motor, and the cutting efficiency is high.
2. It is forbidden to push the knife directly when cutting. There are two reasons. One is that the cutting efficiency is slow, and the other is that the damage to the motor is relatively large. This is also the reason why many customers report that the motor cuts slower and slower.
3. When cutting, the motor must be guaranteed not to enter water.
4. The track is fixed with expansion screws, at least three horizontally and at least two vertically.
5. Regarding the saw blade, it is normal for the consumption of the saw blade head to be relatively large at the beginning of the cutting stage. When the saw blade is cutting, the amount of water passing through and the cutting strength of the cutting steel bar will affect the number of meters the saw blade cuts.
6. Replacement of butter: the gearbox regularly replaces the butter (according to the engineering quantity).
7 Semi-automatic and fully automatic current control is around 18 and no more than 20.
8. The industrial-grade ammeter can be controlled within 20.
9. The expansion core of the implosion screw must be punched open, and the accessory box is equipped with a punch!
10. The wall of the brick wall and the aerated block should be locked with two ends of the wall thread (the kind of long screw) for the best effect.