• Advantages of the item
  •  
  • 1. Difficulty in starting a cold car
  •  
  • 2. The car with petrol
  •  
  • 3. The idle dithering
  •  
  • 4. Easy to stall while driving
  •  
  • 5. Increased fuel consumption
  •  
  • 6. Slow acceleration, obvious lack of power.
  •  
  •  
  • How to Check Your Fuel Pump?
  •  
  • 1

    • For Ford Ranger 2.3L 2.9L 3.0L 4.0L 1989-1997 SP37A1H Fuel Pump Module Assembly

    Advantages of the item

     

    1. Difficulty in starting a cold car

     

    2. The car with petrol

     

    3. The idle dithering

     

    4. Easy to stall while driving

     

    5. Increased fuel consumption

     

    6. Slow acceleration, obvious lack of power.

     

     

    How to Check Your Fuel Pump?

     

    1

    Check the fuel pump fuse. Often, it's not the pump itself that fails to function, but the power that supplies it. Check in your owner's manual for the location of the fuse box, then find the fuse that corresponds to the fuel pump. Pull it out and inspect it for signs of failure. If the fuse is blown, it will be broken or burned. If it looks good, check the rest of the fuses related to the fuel system for signs of being blown and replace them, if necessary. If no fuses are blown, have a helper turn the key while you listen for fuel pump relay clicking on.

    2

    Check the voltage at the pump itself. Just because you're getting juice from the circuit doesn't mean that it's getting to the pump itself, which makes it important to check the voltage there as well. Check out your vehicle's service manual to find out where to check and the proper procedure for checking it.

    Test for source voltage, to determine whether or not the good charge that's leaving the fuse is getting to the pump. If no power is making it to the fuel pump, then check the fuel pump relay circuit. You could have a bad relay.

    3

    Perform a drop test using a voltmeter. Check to make sure that the power wire shows the full voltage and the grounding wire shows that it's grounded properly. If this electrical test reveals nothing, it's likely that your fuel pump is the problem and it will need to be replaced, though you can check more thoroughly by completing an additional pressure test.

     

     

    How to Clean a Fuel Pump?

     

    Method--Spotting the Signs of a Clogged Fuel Pump
    1
    Watch out for engine “sputtering” or stalling.
    2
    Listen for a clicking or whining from the pump when the car idles.
    3
    Look for a drop in RPMs as you drive.
    4
    Consider if you often run the vehicle with low fuel.

     


    Package Contents

     

    1x FUEL PUMP MODULE ASSEMBLY


    Item Specifics
    Brand auspartshouse
    Manufacturer Part Number 9867068
    Voltage 12V
    Fitment Type Direct Replacement
    Manufacturer Warranty 1 Year
    Mounting Hardware Included No
    Interchange Part Number 402-P2078S
    Other Part Number E2078S
    Custom Bundle No
    Modified Item No
    Color White
    Quantity 1
    Packaging Type Box
    Placement on Vehicle Rear
    Superseded Part Number HK05239003CP
    Fuel Pump Type Electrical
    Compatible Fuel Gas
    Confirm Standard Cab Pickup
    PSI 70-95
    Gallons Per Hour (GPH) 30-40
    Outlet Type Quick Connect, Return Line
    Outlet Size 3/8
    Inlet Type Strainer
    Terminal Type PIN
    Pin Quantity 4

    Payment
    We use eBay's Safe and Secure Checkout. Just click the Pay Now button at the top of any of the auctions you have won.
     
    To pay for multiple auctions, successfully win all auctions you wish to purchase and then click the Pay Now button on any of the listings you won. You will only have to checkout and pay once for your entire order.
     
    Please review our detailed policies on shipping and fixing any issues before purchasing the item. If you have any questions, please email us through "Ask a question".
     
    Payment Options: Any payment which can be accepted by ebay.
     
    If you want to change the shipping address, please contact us by eBay messages within 12 hours.
     
    Payment must be received within 10 days as auction ended or order might be delayed.
    Shipping

    1. More than 90% orders processed within 24 hours of payment verification.

    2. We only ship to the address in order provided to us. Your order address will be the shipping address.

    3. The images shown is the the actual item you will get and the size are for your reference.

    4. If you have not received your shipment within 15 days from payment, please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!

    Returns

    1. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.

    2. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.

    3. Return shipping is to be paid by the Buyer if the problem turned to be buyer's end, or return will be seller's responsibility.

    Feedback

    We maintain high standards of excellence and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.

    Contact Us

    Any question or problem, please feel free to contact us via ebay message.

    Just Get It NOW

    content_src_url

    Shop Category
     Store Home
     Wheel Spacers
     Leveling Lift Kits
     3RD Brake Lights
     LED Instrument Lights
     Tire Pressure Sensors
     Fasteners
     Remote Keys
     Sun Visors
     Roof Racks
     Ballast Modules
     Rubber Seal Strips
     Throttle Body
     Thermostat Housing
     Fuel Injectors
     Coilovers
     Ignition Coils
     Wheel Hub Bearing
     Suspension Kits
     Window Regulators
     Sensors
     Mud Flaps
     Lift Supports
     Resistors
     HVAC Blower Motors
     Radiators
     Cooling Fans
     Coolant Overflow Tanks
     Engine Gaskets
     Blend Door Actuators
     Air Suspensions
     AC Condensers
     Heater Cores
     Window Switches
     Door Handles
     Shock Struts
     Windshield Wiper Motors
     A/C Compressors
     Timing Chain Kits
     Timing Belt Kits
     Turbochargers
     Radiator Supports
     Mirrors
     A/C Evaporators
     Engine Motor Mounts
     Starters
     Alternators
     Brake Calipers
     Power Steering Pumps
     Tensioners
     Brake Rotors
     Brake Pads
     Fuel Pumps
     Water Pumps
     Driveshafts
     Idle Air Control Valves
     Power Steering Rack & Pinion
     VVT Variable Valves
     Lug Nuts
     Steering Shafts
     CV Axles
     Hydraulic Lifters
     Towing Parts
     Steering U-Joint Parts
     Door Lock Actuator
     AC Compressor-d
     Spoilers & Wings
     Truck Bed Accessories
     Lawn Mower Parts
     Oil Pump
     Bumper
     Armrest Cover
     Horn
     Truck Bed Mat
     Side Steps Running Boards
     Cylinder Piston Gasket
     Bed Step
     Mass Air Flow Sensor
     Dipstick
     Headlights Assembly
     Harmonic Balancer
     Hub Cap
     Tire Chain
     Sway Bar Bushing Kit
     Wheel Hub Bearing Knuckle
     Cargo Cover
     Spark Plug
     Strut Mount
     Coil Spring
     Differential Assembly
     Radiator Shutter
     CV Axle Boot Kits
     Other
    Hot Item
    New List Item
    For Ford Ranger 2.3L 2.9L 3.0L 4.0L 1989-1997 SP37A1H Fuel Pump Module Assembly

    Advantages of the item

     

    1. Difficulty in starting a cold car

     

    2. The car with petrol

     

    3. The idle dithering

     

    4. Easy to stall while driving

     

    5. Increased fuel consumption

     

    6. Slow acceleration, obvious lack of power.

     

     

    How to Check Your Fuel Pump?

     

    1

    Check the fuel pump fuse. Often, it's not the pump itself that fails to function, but the power that supplies it. Check in your owner's manual for the location of the fuse box, then find the fuse that corresponds to the fuel pump. Pull it out and inspect it for signs of failure. If the fuse is blown, it will be broken or burned. If it looks good, check the rest of the fuses related to the fuel system for signs of being blown and replace them, if necessary. If no fuses are blown, have a helper turn the key while you listen for fuel pump relay clicking on.

    2

    Check the voltage at the pump itself. Just because you're getting juice from the circuit doesn't mean that it's getting to the pump itself, which makes it important to check the voltage there as well. Check out your vehicle's service manual to find out where to check and the proper procedure for checking it.

    Test for source voltage, to determine whether or not the good charge that's leaving the fuse is getting to the pump. If no power is making it to the fuel pump, then check the fuel pump relay circuit. You could have a bad relay.

    3

    Perform a drop test using a voltmeter. Check to make sure that the power wire shows the full voltage and the grounding wire shows that it's grounded properly. If this electrical test reveals nothing, it's likely that your fuel pump is the problem and it will need to be replaced, though you can check more thoroughly by completing an additional pressure test.

     

     

    How to Clean a Fuel Pump?

     

    Method--Spotting the Signs of a Clogged Fuel Pump
    1
    Watch out for engine “sputtering” or stalling.
    2
    Listen for a clicking or whining from the pump when the car idles.
    3
    Look for a drop in RPMs as you drive.
    4
    Consider if you often run the vehicle with low fuel.

     


    Package Contents

     

    1x FUEL PUMP MODULE ASSEMBLY

    Item Specifics
    Brand :auspartshouse
    Manufacturer Part Number :9867068
    Voltage :12V
    Fitment Type :Direct Replacement
    Manufacturer Warranty :1 Year
    Mounting Hardware Included :No
    Interchange Part Number :402-P2078S
    Other Part Number :E2078S
    Custom Bundle :No
    Modified Item :No
    Color :White
    Quantity :1
    Packaging Type :Box
    Placement on Vehicle :Rear
    Superseded Part Number :HK05239003CP
    Fuel Pump Type :Electrical
    Compatible Fuel :Gas
    Confirm :Standard Cab Pickup
    PSI :70-95
    Gallons Per Hour (GPH) :30-40
    Outlet Type :Quick Connect, Return Line
    Outlet Size :3/8
    Inlet Type :Strainer
    Terminal Type :PIN
    Pin Quantity :4


    We use eBay's Safe and Secure Checkout. Just click the Pay Now button at the top of any of the auctions you have won.
     
    To pay for multiple auctions, successfully win all auctions you wish to purchase and then click the Pay Now button on any of the listings you won. You will only have to checkout and pay once for your entire order.
     
    Please review our detailed policies on shipping and fixing any issues before purchasing the item. If you have any questions, please email us through "Ask a question".
     
    Payment Options: Any payment which can be accepted by ebay.
     
    If you want to change the shipping address, please contact us by eBay messages within 12 hours.
     
    Payment must be received within 10 days as auction ended or order might be delayed.

    1. More than 90% orders processed within 24 hours of payment verification.

    2. We only ship to the address in order provided to us. Your order address will be the shipping address.

    3. The images shown is the the actual item you will get and the size are for your reference.

    4. If you have not received your shipment within 15 days from payment, please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!

    1. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.

    2. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.

    3. Return shipping is to be paid by the Buyer if the problem turned to be buyer's end, or return will be seller's responsibility.

    We maintain high standards of excellence and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.

    Any question or problem, please feel free to contact us via ebay message.


    All rights reserved.