YIELD DESIGNS™
Reproduction End Clips for 1992 & 1993 Flareside; 1994, 1995, 1996, & some 1997 F-series (F150, F-150, F250, F-250, F350, F-350) & Broncos
with factory cab steps
These are the small L-brackets used to bolt the front (and rear on Broncos) ends of the factory optional fiberglass cab steps to the body. For the main supports, check my other listings.
https://www.ebay.com/itm/297348024624
The fasteners are NOT included, and the clips are bare (mill scale) steel, ready for you to undercoat, paint, or powdercoat. The front clips (#7 yellow in the diagram) are bolted to the step's bonded steel bridges (available separately) using YOUR M6x1.00 bolt and a matching U-nut on the step. They are attached to the body by the rearmost screw for the plastic wheelwell at the bottom of the fender. One pair is needed for one F-series or Bronco.
Broncos (only) use similar rear end clips (#10 orange in the diagram) attached the same way to the step, and to the body by the front lower bolt of the rear wheelwell flap under the quarter panel. One pair is needed per Bronco.
The bridges (available as pairs for F-series & Broncos - purple, or as a set of 4 for Broncos - purple & green) are to be bonded (glued) to the steps using your panel adhesive, polyester epoxy resin, or similar.
There are several shipping options, so review them during checkout. These are also available locally, so the quantity may change, or the listing may be ended at any time. If any quantity reaches 0, let me know - I have parts to make more.
Check my other listings for more '92-96 Broncos & F-series parts.