ARRMA BIG ROCK 3s V3 Mega 4x4 REAR GUARD Rails Bars Skid Protection Complete Set
Condition: New Unused Custom Made & 3-D Printed
Colours: Black, Carbon Black*, Carbon Grey*, Red, Blue, Green  //  Hex Bolts: Black or Silver

*** If you do not see the colour combination you require - please message. ***

3-D Printed using premium PLA & TECBEARS PLA (*Carbon Black/Grey uses PLA with  up to 20% Carbon Fibre)
Adds protection to the body shell to which they are fitted.

Supplied: Roof Skid Plate / Side Rails / Rear Guard, Backing Plate, 4 x hex bolts  & 4 x backing nuts (silver)

Measurements (approx.)
Rear
Rear Guard  L: 55mm, H: 7mm, W: 120mm
Backing Plate  L: 55mm, H: 5mm , W: 12mm
Roof Plate
Roof Plate   L: 98mm, H: 9mm, W: 85mm
Backing Plate   L: 80mm, H: 4mm, W: 10mm
Side Rails
Side Rails   L: 98mm, H: 9mm, W: 10mm
Backing Plate   L: 80mm, H: 4mm, W: 10mm
 
Fitting
You will need to make 4 small holes in the shell to mount skid plate / side rails / rear guard, use the backing plate as a guide for hole location.
Position the roof plate / rails to sit behind the front row of bumps on the roof as in the pictures.  Do not position too far forward, the front door pillars slope away quickly and it leaves a gap between the front of the rail and the roof. 
Do not over tighten the bolts.

The skid plate / rails / rear guard will scratch-up and wear down, they are not indestructible!

Not Included
Shell 
RC Car

Disclaimer
All 3D printed objects are susceptible to small superficial surface imperfections such layer lines, tiny gaps, small blobs.  Quality control means each piece is finished by hand and checked before dispatch.  Please see feedback comments for the excellent quality of these pieces.  
PLA printed parts should not be exposed to extreme temperatures as the strength of the product can be compromised (< 10c (50F) > 40c (104F)).