Auto Program

The Auto Program feature enables easy programming of the Network address and Fixture address. Just a press of the button and the fixture auto programs to the selected button on the remote. The network address and the fixture address are saved to memory. Turning off the fixture or loosing power will not affect the settings. The Fixture can be programmed as may times as needed.

Control Panel

The DL200 control panel has a setup switch used to start the Auto address feature and switch the ColorRoll feature on and off. The indicator light identifies fixture settings currently programmed.

Internal SLA Battery

DL200 is powered by 2 internal 2.5 AH sealed lead acid batteries for up to 7.5 hours of run time at full RGB. DL200 can be recharged in 5 hours by one our of SLA battery chargers.

Battery Protection

The DL200 has a built in battery protection device that will automatically turn off the DL200 power to protect the battery from discharging below a safe level.

Low Profile Radio Antenna

The domed antenna is a high sensitivity antenna and very low profile to allow the fixture to be used in an application where cosmetic appeal is required.

Applications

DL200 can be used as a table illuminator, centerpiece and truss lighting. When used as a centerpiece light its recommended that items placed on the fixture lens do not exceed 1 pound. If heavier items are needed use an acrylic plate over the top of the fixture so items do not reset on lens.

Physical Specifications

Length: 7.6 inches
Width: 7.6 inches
Height: 2.4 inches
Weight: 7.5 lbs

Operating Temperature: -30o C to +70o C

Duty Cycle: 100%

LED bulb life: 100,000 Hours
LEDS: 36 Red, 36 Blue, 36 Green

shelf m15