Gibson Les Paul Solderless wiring harness with custom coil split
+ Custom coil split for fuller single coil sound with more sustain
+ Custom value tone capacitors for more neck highs
Completely wired (not a kit) Ready to install
Charlies Gear USA
Custom specs see below
Features:
For models with long shaft potentiometers and short frame switch (see size chart @ pictures)
Solderless installation & solderless future pickup swaps
Coil split for both pickups - pull up tone knob for partial coil split
6.8k resistors added for partial split for fuller single coil sound / more sustain
50's wiring
22-gauge wiring
Shielded cables from switch to jack to protect your signal from RF interference noise
Quick connector on switch cable for easier installation - Just plug it in
Multi-contact jack with 100% more signal transfer area
Orange drop tone capacitors:
Bridge .022uf
Neck .015uf to retain more highs
2 string grounding options included
All components are USA specs
Scroll down for component specs
Easiest installation & future pickup swap system available
Installation:
This system is designed to make upgrading your electronics with premium components easy, quick and frustration free.
1- Install your stripped wires into the solderless terminal ports & secure with the included screwdriver
2- mount your new harness in the control cavity
3- plug the solderless terminal into the harness.
BING - BANG - BOOM - DONE!
Plus, no burned fingers!
***Makes future pickup upgrades a snap***