10-32 Microdot Plug to Microdot Plug Cable Assembly — RG316

Ready-made 50 Ω cable assemblies with a 10-32 Microdot plug (conventional male) on each end, built on flexible RG316 PTFE-insulated coaxial cable. Select your required length from the options above.

The 10-32 UNF Microdot connector is the industry-standard interface on most piezoelectric accelerometers, IEPE/ICP vibration sensors, ultrasonic transducers, and acoustic emission sensors. These assemblies connect two Microdot-equipped devices directly — sensor to junction box, sensor to sensor, or as a short patch between instruments.

Why RG316

RG316 is a PTFE (Teflon) insulated cable with excellent temperature resistance and lower signal loss than RG174. It is the standard choice where measurement accuracy matters — test labs, research environments, and industrial monitoring systems that may see elevated temperatures or chemical exposure.

Key Features

• 10-32 Microdot plug (conventional male) on both ends
• RG316 PTFE-insulated cable — temperature resistant, low loss
• 50 Ω impedance
• Available in 350 mm, 400 mm, 500 mm, 750 mm, 1 m, 1.53 m, 2 m, and 3 m
• Finished assemblies — ready to use, not loose connectors or bulk cable

Technical Specifications

Connector (both ends)	10-32 Microdot Plug (conventional male)
Cable Type	RG316 (PTFE insulated)
Impedance	50 Ω
Lengths Available	350 mm, 400 mm, 500 mm, 750 mm, 1 m, 1.53 m, 2 m, 3 m

Typical Applications

• Accelerometer and vibration sensor connections (IEPE/ICP and charge mode)
• Ultrasonic transducers and flaw detectors (NDT / non-destructive testing)
• Acoustic emission monitoring and structural health
• Modal analysis and vibration testing setups

Before You Order

• Confirm your sensors use 10-32 UNF Microdot connectors (not 12-32)
• This is a finished cable assembly — not loose connectors or bulk cable
• RG174 versions are also available if you need a more flexible, lower-cost cable for longer runs