Technics * SFPJL00101K * Cue Lever Cylinder *  SL-Q3 SL-D1 SL-D2 & others

This is a 3D printed part as originals are hard to come by. Part number is SFPJL00101K and is known to fit many models

Please Google for your models service manual and then check the part number is correct before ordering.

I have successfully replaced this part on my own turntable and got a few extra printed.

The little metal cueing lever fits into this part, you need to disassemble your turntable and get under the tonearm to replace it then pop some super glue onto the metal cue lever and push it into the the hole

The last 2 photos show the where you have to get to. The red line is where the part is located. The circled brass bit is part of the anti skate and there is no need to remove it as suggested in the forums, just remove the antiskate dial on the other side and the mech will then pop out. You will know what I mean if you have read the Reddit or other forums for replacing this part. Last phot is the old broken part.

Its not difficult if you have done this sort of thing before, if its your first go check the service manual and take many photos so you can refer to them to get it back together!

Will be sent 48 hour Royal Mail tracked