Aqua One Breeder Trap

The all in one solution for breeding.

Comes with all the accessories for an all-in-one, self-contained also live-bearer breeding tank.

A safe floating haven for live-bearing fish and fry, it has a chamber for expectant fish and also a V-shaped bottom compartment that safely collects and protects falling fry.

• Easy to use
• Easy to clean

Available Sizes:

• Mini Trap (16 x 8 x 7.5cm)
• Midi Trap (19.5 x 10.5 x 10cm)

Aqua One Fish Breeder Net

Provides a safe place for pregnant, weak or sick fish who require temporary isolation. The Net Breeder & Separation Box can be easily attached to your aquarium with the included suction cups.

Directions:

1. Place the base on a flat surface. Insert a post into each corner by pushing down firmly. Ensure the channel on the posts are facing the opposite posts, towards the suction cup pins and that the stop is closer to the base.

2. Lower the base separator into position, with a post fitting through each corner as shown. Push the base separator down until it reaches the stops on the posts.

3. Insert the centre separator through the holes on the base. Place the top onto the posts and push down firmly to ensure the entire frame is sturdy. Ensure the suction cup pins on the base and top are facing the same direction.

4. Slip the net over the base frame and pull upwards. Insert the 4 suctions cups on to the pins on the rear of the top and base frame, then rinse the assembled frame and net in tap water.

5. Simply attach the Net Breeder & Separation Box to a wall in your aquarium with the suction cups. Ensure the top is 1-2 cm above the water level to prevent fish accidentally jumping in or out.

Measurements: 15.5 W x 14 D x 15cm H