A good-quality penetrating adhesive with a liquid consistency, designed for joining plastic model parts with an average curing time (commonly referred to as drying time). It comes in a stable 40 ml container with a square base, which makes it difficult for the adhesive to tip over during use. It also has a special brush (attached to the cap) for easy application. Its key ingredients are solvent, butyl acetate, and acetone. Its chemical properties allow you to first perfectly match the parts of the plastic model to be joined and then apply the glue to their outer sides. What is more, the presented substance not only penetrates even the smallest gaps between the joined surfaces, but also “evaporates” relatively quickly from the remaining areas, leaving almost no trace. For this reason, it is also very well suited for filling smaller gaps in the glued model, replacing modeling putty in this role. It is recommended for use primarily when gluing rather large surfaces of plastic models, but it can also be successfully used when joining modeling details (e.g., aircraft antennas). It will prove particularly useful when working with miniatures of ships and boats in 1:350 and 1:700 scales or aircraft in 1:32, 1:48, and 1:72 scales.