Features:
Solderless installation & solderless future pickup swaps
Master volume / master tone / 5-way blade switch
For humbucker bridge/Single coil mid/Humbucker neck models (HSH)
Push/pull tone coil splits Bridge & Neck - Pull up knob for single coil
Resistor added for single coil / humbucker combination - so each pickup "sees" the correct potentiometer value for the pickup type
SWITCHING:
This has a 5-way switch with the following switching:1- B2- B+M3- M4- M+N5- N
Dedicated control cavity ground to reduce noise
Bourns pro-audio 17mm potentiometers - High quality in a smaller package
Multi-contact Barrel jack with 100% more signal transfer area
Shielded cable to jack to protect your signal from RF interference noise
Quick-connector on jack cable - just plug it in (1/4" clearance required at feed-thru hole to jack)
2 grounding options included for strings & hardware
Orange drop tone capacitor
USA spec components
Scroll below for complete component specs
Upgrading an import? These upgraded potentiometers & jack require 3/8" diameter mounting holes. Hand reamers are the safest, easiest & best way to enlarge holes. You can find very affordable hand reamers in Charlies Gear store at the "Helpful tools" category if you need one.
Installation:
This system is designed to make upgrading your electronics with premium components easy, quick and frustration free.
1- Install stripped wires into the solderless terminal ports and secure with the included screwdriver
2- Mount your new harness in the control cavity
3- Plug the solderless terminal into the harness.
BING - BANG - BOOM - DONE!
Plus, no burned fingers!
***Makes future pickup upgrades a snap***