Reavon UBR-X110 Reference Power Supply - Very low noise linear PSU - DIY Install

This pcb is designed to replace the cheap and noisy SMPS PSU in the Reavon UBR-X110.

Only Fidelity Audio design and build true low noise PSUs.

Custom Dual SPower Reference derived very low noise voltage regulation
Fully Regulated PSU
Triple Vref voltage control on 5v output
Dual Vref voltage control on 12v output
Oscon SEPC capacitors
F&T SI decoupling capacitor (Pre Regulation 5v)
F&T SI decoupling capacitors (Post Regulation 5v)
SLPX decoupling capacitor (Pre Regulation 12v)
SLPX decoupling capacitors (Post Regulation 12v)
Panasonic PPS decoupling capacitors used throughout
Optimised circuit layout
4A Current capable
6.67A Current Max @ 5V (short term current)

Disclaimer - We take every step to make sure our products are built to the highest standard and specification.
Do-It-Yourself (DIY) projects and all DIY projects are purely “at your own risk”. As with any DIY project, unfamiliarity with the tools and process can be dangerous.
If you are at all uncomfortable or inexperienced working on these projects (especially but not limited to electronics and mechanical), please reconsider doing the job yourself. It is very possible on any DIY project to damage your equipment if not properly installed.

DISCLAIMER - We take no responsibility for damage to your Reavon with a DIY installation.

This PSU cannot damage your Reavon. The Reavon has further regulation after the PSU. From extensive testing only bad installation can damage your Reavon. Check all cables between pcbs are aligned correctly.

Shipping

Most of our items are built to order and can take over 1 week to arrive. We use a courier so that once the product / item is ready we can get it to you as quickly as possible. All our parcels are trackable.