|
basic skills
|
VICTOR 9000E
|
VICTOR 9000F
|
|
Model distinction
|
Fork type (which can be switched from different angles)
|
Check type (switching from different angles)
|
|
Features
|
High-voltage AC current measurement, low-voltage AC current, online AC current monitoring
|
|
power supply
|
DC6V alkaline dry battery (1.5V AAA×4)
|
|
test method
|
Non-contact U-CT
|
|
transfer method
|
433MHz wireless transmission, the transmission distance is about 100 meters
|
|
Display mode
|
4-digit LCD display, backlight function, suitable for dim places
|
|
LCD size
|
47mm×28.5mm
|
|
Instrument size
|
Tester: 107mm × H 252mm × thick 31mm; Receiver: 78mm × H 212mm × thick 41mm
|
Tester: Wide 210mm × Hight 246mm × thick 45mm; Receiver: Width 78mm × Hight 212mm × thick 41mm
|
|
Jaw size
|
φ68mm
|
φ128mm
|
|
Insulating rod size
|
φ45mm, closed state 1150mm, extended state about 4500mm.
|
|
Insulating rod voltage level
|
110KV
|
|
Sampling rate
|
2 times/sec
|
|
Measuring range
|
0.00A~9999A (50/60Hz automatic)
|
|
Resolution
|
0.01A
|
|
Change files
|
0.00A~9999A fully automatic gear shift
|
|
Test accuracy
|
±2%±5dgt (The wire is located near the center of the bottom end of the U-shaped jaw, 23℃±2℃)
|
|
Position error
|
The wire under test should be as close as possible to the center of the bottom end of the U-shaped jaw
|
|
data storage
|
99 groups, the "MEM" symbol indicates during the storage process, and the flashing display of the "FULL" symbol indicates that the storage is full
|
|
Line voltage
|
Test of bare wires below 60kV (operation with insulating rod, fully extended telescopic insulating rod)
|
|
Data retention
|
In the normal test mode, press the HOLD key to keep the data, the "HOLD" symbol is displayed, and then press the HOLD key to cancel
|
|
Data access
|
The "MR" symbol indicates that the stored data can be flipped up and down
|
|
Overflow display
|
Over-range overflow function: "OL A" symbol display
|
|
No signal indication
|
When the receiver does not receive the transmitted signal, the "no- -" symbol is displayed dynamically
|
|
Automatic shut-down
|
About 15 minutes after power on, the meter will automatically shut down to reduce battery consumption
|
|
Instrument quality
|
Detector: 235g (including battery), receiver: 280g (including battery, total mass of the meter: 2300g (including insulating rod and battery)
|
|
Working temperature and humidity
|
-10℃~40℃; below 80%Rh
|
|
Interference
|
Try to avoid 315MHz, 433MHz co-frequency signal interference
|
|
Dielectric strength
|
AC 220kV/rms (the telescopic insulating rod is fully opened, between the two ends)
|
|
Random accessories
|
Clamp meter: 1 piece; receiver: 1 piece; telescopic insulating rod: 1 piece; battery LR03: 8 pieces; cloth bag: 1 piece
|