Smart and efficient. Program a transponder key in about 20 seconds! No 30 minute wait, no pin codes. Just connect to the OBDII port and go. Simply the fastest way to program TOY44D  keys

Compatibility with the following:

    2005-2008 Toyota Corolla

    2005-2008 Pontiac Vibe

    2005-2008 Toyota Matrix


  OE: 89742-AA030
    FCC ID: GQ43VT14T
    Frequency: 315 MHz
    Battery: CR2032
    Buttons: Lock, Unlock, Panic


  
    Toy44D Transponder Key
    Chip: 4D67 (Master)
    Test Key: TR47
    Cross Reference: TOY44D-PT, 5910834, 89785-08020, 89785-60160

Program Key 

Programming Instructions :

To program keys when all keys have been lost:
1. Using the transponder master key, switch the ignition to the “ON” position
2. Insert the tool into the OBDII port. You will hear one beep. After about 3 seconds, tool will beep 3 more times indicating that the vehicle has been placed into programming mode.
3. Remove the tool and the key.
4. Perform the following steps to program the keys: a. Close all doors b. Insert the first master key for 5 seconds (do not turn) c. Insert the second key for 5 seconds (do not turn) d. Insert the valet key for 5 seconds (do not turn) e. Programming mode should automatically end. If, for some reason, you need to end programming mode manually, simply insert and remove the first master key 5 times (do not turn).
 
To program additional keys when you have one working master key:
1. Using the working master key, switch the ignition to the “ON” position
2. Insert the tool into the OBDII port. You will hear one beep. After about 3 seconds, tool will beep 3 more times indicating that the vehicle has been placed into programming mode.
3. Remove the tool and the key.
4. Perform the following steps to program the keys: a. Close all doors b. Insert the first master key needing programming for 5 seconds (do not turn) c. Repeat step B for each key needing programming d. Insert and remove the original master key 5 times (do not turn) to end programming 

Program Remote
Programming instructions:
  1. Start by sitting in the car with the key out of the ignition, Open drivers door. (step 2 and 3 has to be done within 5 seconds)
  2. Insert the key into the ignition and Pull it out
  3. Insert the key into the ignition and Pull it out
    Perform these steps within 40 seconds. Drivers door is still open.
  4. Close drivers door and open the drivers door.
  5. Close drivers door and open the drivers door.
  6. Insert the key into the ignition and Pull it out
  7. Close drivers door and open the drivers door.
  8. Close drivers door and open the drivers door.
  9. Insert the key into ignition and leave it in ignition.
  10. Close the drivers door.
  11. Turn the ignition to the “ON” position and then to “OFF” position.
  12. Pull out the key from the ignition.
    ** the power door locks should lock then unlock so you are in programming mode and ready to program the remotes. If this does not happen start again**
    Remote programming has to be done within 40 seconds.
  13. Press both the lock and unlock buttons on the remtoe for about 1 and 1/2 seconds then let go
  14. Press lock button for 2 seconds and let go. The car doors should lock and unlock. If they do then you are ready to program the next remote.
  15. Open drivers door to end programming mode.

https://www.youtube.com/watch?v=9WZyYctRBNg&t=2s

https://www.youtube.com/watch?v=HpsHhNOaDes