MADE IN THE USA

1936 CHEVY GRILLE EMBLEM DECAL SET

EASY PEEL AND STICK TECHNOLOGY

high performance industrial vinyl.

quick and easy, no masking or messy paint to clean up,

INSTALLS IN MINUTES

with this purchase you get:

• 1 BLUE CHEVROLET BOWTIE INSERT


• 2 RED HALF SHIELDS


• 2 BLUE LEFT & RIGHT STRIPES


DECALS ONLY HARD PARTS ARE NOT INCLUDED IN THIS SALE

INSTRUCTIONS:

WATCH OUR YOU TUBE VIDEO SEARCH: DIY 1936 Chevy Grille emblem detailing

apply to a clean cool to the touch emblem

you can use an exacto knife for best results however a toothpick or tweezers will do just fine

1. Prop the emblem up on top of a wood block or spray can cap etc. It must be facing you


2. using an exacto knife, tweezers, toothpick or even just your fingers remove the top red shield portion from the backing.


3. place the left corner on first matching the lower straight edge to the decal. apply from left to right.


4. using an exacto knife, tweezers, toothpick or even just your fingers remove the bottom red shield portion from the backing.


5. place the left upper corner on first matching the upper straight edge to the decal. apply from left to right.


6. using an exacto knife, tweezers, toothpick or even just your fingers remove the left side blue pin stripe portion from the backing


7. place the inside end (thickest part) first matching the upper straight edge to the decal. apply from right to left.


8. using an exacto knife, tweezers, toothpick or even just your fingers remove the right side blue pin stripe portion from the backing


9. place the inside end (thickest part) first matching the upper straight edge to the decal. apply from right to left.


10. using an exacto knife, tweezers, toothpick or even just your fingers remove the right side of the blue bowtie and gently lay it over the emblem aligning the letters of the left side first. as you're laying down the decal rub your fingers over the decal to help it along in the adhering to the surface.

11. remove the transfer tape slowly from left to right from the backing.


12. apply to the decal aligning the bottom edges first lay the decal down and from the middle out rub the entire decal in to all the crevices to make sure the decal adheres to the emblem and away from the transfer tape.


13. remove the transfer tape slowly from the bottom to the top angling it from the right. (remove more from the right side than the left).


14. remove the blue inserts for the shield and put them in place using your exacto knife, tweezers or finger tips,


15. once done applying the decals go over the entire set of decals rubbing your finger nails through all the crevices to ensure adherence.