Valve Cover Gasket - Silicone
fits
Chevrolet - Straight 6-cylinder
- Our silicone rubber gaskets are made from aerospace mechanical
grade AMS silicone and designed to withstand temperatures
up to 400 degrees Fahrenheit.
- Therefore, they will not break down and deform or crack up
like cork or
neoprene.
- Our gaskets seal uneven and warped surfaces,
and eliminate
corrosion.
-
Gaskets are 100% reusable.
FITS: Chevrolet
1937-1962 Straight 6-cylinder - 216 & 235 CID
1954-1962 261 CID
PART #: RG-50190
Corresponding part #: OEM # FelPro VS50190C; CVC-3
One silicone gasket.
Silicone gasket has four (4) bolt holes and is 1/8" thick.
Reusable.
INSTALLATION INSTRUCTIONS:
Wash the cover and cylinder head surfaces with solvent.
Remove all traces of oil.
The gasket must be installed DRY (No oil or lube of any type).
TORQUE TO 20-25 INCH POUNDS.
DO NOT OVER TIGHTEN!
Don't over tighten as that causes the gasket to bulge or squeeze out.
TO REUSE GASKET:
Wash gasket briefly in hot water and soap.
Rinse well, dry thoroughly.
Re-install using the above installation instructions.
Proudly made in the USA.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
USE CORK? GET REAL! REAL Gaskets that is…
REAL Gaskets
for aircraft, automobile, and motorcycle engines.
Our silicone rubber gaskets are made from aerospace mechanical
grade AMS silicone, designed to withstand temperatures up
to 400 degrees Fahrenheit and to last the life of the engine.
Our gaskets seal uneven surfaces, eliminate corrosion and
are 100% reusable.
We manufacture valve cover gaskets for:
Aircraft: Continental, Franklin, Lycoming, Pratt & Whitney and
Wright radial piston aircraft engines.
Automobiles: Ford, GM, Mopar, Porsche and VW automobile
engines.
Motorcycles: BMW, Harley-Davidson, Suzuki, BSA, Ducati,
Moto Guzzi, Norton, Triumph, Saab and most other
motorcycle engines.
If you are tired of oil leaks, then a silicone rubber gasket is
the only way to go, and REAL Gaskets Tennessee is the
only place you can get “The Original”
silicone rubber gasket.
MADE IN THE USA.