PLC  – HCA1- 8X  6 Y  R – D

The PLC unit comes with online software as well as hardware manuals.

Specifications:

INPUT:  8 inputs, type 24V DC

OUTPUT: 6 outputs, type RELAY

Power Supply: 24 Volts DC

Dimensions: W=60 mm, H= 90 mm, D= 49 mm

Weight: 220 grams

Programming essential:  USB module (optional $ 55 extra)

You don’t need the USB modules for all PLC units. One can be used to program many units.

We may also help you with the programming of your project; the cost will be by negotiation, which varies depending to the complexity of your project.   

Manuals and installation:

• The manual contains text, diagrams and explanations which will guide the reader in the correct installation and operation of the HCA1 Series Programmable Controllers. It should be read and understood before attempting to install or use the unit.

• If in doubt at any stage of the installation of an HCA1 Series Programmable Controller always consult a professional electrical engineer who is qualified and trained to the local and national standards which apply to the installation site.

• If in doubt about the operation or use of HCA1 Series Programmable Controller please consult ASA Industry – Melbourne.

Guidelines for the Safety of the User and Protection of the HCA1

The manual provides information for the use of the HCA1. The manual has been written to be used by trained and competent personnel. The definition of such a person or persons is as follows:

a) Any engineer who is responsible for the planning, design and construction of automatic equipment using the product associated with this manual, should be of a competent nature, trained and qualified to the local and national standards required to fulfill that role. These engineers should be fully aware of all aspects of safety with regards to automated equipment.

b) Any commissioning or service engineer must be of a competent nature, trained and qualified to the local and national standards required to fulfill that job. These engineers should also be trained in the use and maintenance of the completed product. This includes being completely familiar with all associated documentation for said product. All maintenance should be carried out in accordance with established safety practices.

c) All operators of the completed equipment (see Note) should be trained to use this product in a safe manner in compliance to established safety practices. The operators should also be familiar with documentation which is associated with the operation of the completed equipment.