PLEASE MAKE SURE YOU KNOW IT IS YOUR PCB AT FAULT BEFORE PURCHASE, THE MOST COMMON REASON FOR THE MOTOR TO STOP WORKING IS THE TRIAC PCB INSIDE THE ACTUAL MOTOR ITSELF.

GUIDELINES = if when you power on your vacuum NO LIGHTS come on your panel then that is most likely a issue with your power cable unit, if however a single light come on but no motor runs, then the light goes out that is more likely a FAULTY MOTOR, the pcb is usually only at fault if you have BURNT terminals obviously seem on the back of the board, or your switch itself is faulty but if you can’t see any obvious burning marks on your pcb then it usually is fine and the MOTOR is the issue, this is just a guide as I have had vacuums where both the pcb and motor was faulty, yours may have more than one issue, the items I sell have been FULLY TESTED and I only sell them if they are FULLY WORKING so please don’t open false returns if the item purchased doesn’t fix your issue, that means you purchased the wrong item and your fault was something different.

MIELE VACUUM CLEANER PART

Model = C3 Total Solution = SGFF3.

Item = 1 x PCB control board with switch, EDW-S15303(if your sticker has come off then check the bottom of the board which will have EDW-S15503), part number = 11120880.

Fully Working Order, goes up and down the power levels smoothly.

I do security mark these for security purposes.

See pictures for actual item.

This is a genuine miele used part, it will have scuffs and scratches from daily use, i have tried to show in pictures.

Anything attached to it will be left on, what you see is what you get but its a good replacement if yours has broke.

FREE UK POSTAGE.