Freshen up the look of your Ferrari with a set of clear side markers to replace the OEM orange side markers.

Includes 2 high quality, omni-directional T4W LEDs that light up vivid amber color to replace the OEM incandescent bulbs. These LEDs will not cause a bulb fault to show on your dash. I tested many different LEDs before arriving on the LED with the ideal combination of brightness, light dispersion angle and quality.

Easy and perfect fit replacement of your factory markers.

Fits Ferrari 348, 355, 360 430, 458, 488, 550, 575, 599, FF, F12, California models.

Installation instructions:
  • Pry the OEM orange lens off using a small flat head screw driver or trim removal tool between the lens and the rubber molding boot. The rubber boot stays attached to the fender initially.
  • Wiggle the rubber boot outward. There are 2 pieces to it that are loosely pressure fitted together. It's ok if the front boot separates from the rear boot, but don't let the rear boot and light harness fall into the fender.
  • Wiggle the rear boot with the light harness out of the fender. A small screw driver can help to get the boot through the fender hole. Once out, pull the wire harness through the fender hole a few inches so that it doesn't pull back into the fender.
  • Remove the factory bulb (twist and pull) and replace with the included LED bulb.
  • To reassemble, press the 2 rubber boot pieces together around the LED light. Make sure the rear boot is pulled forward towards the LED as much as possible. You can use the included front boot or reuse your OEM one if it's in good shape.
  • Keeping the 2 boot pieces together, wiggle them along with the LED back into the fender hole. It is best to only apply pressure to the front boot (not the bulb) as you wiggle it in. If you put pressure on the LED, you may cause the LED and rear boot to separate from the front boot and fall into the fender.
  • Once the LED and boots are inserted flush with the fender, insert the included clear lens into the front boot. Wiggling it in a circular motion will cause it to move into place and sit flush with the boot.
If you're looking for smoked side markers, see this listing.