THIS KIT CAN BE PLUGGED INTO A 2008 OR 2009 SUZUKI GSXR 750 WITHOUT ANY MODIFICATIONS NECESSARY.  Fine tuning can be done but you won't have to send out your ecu or go the the dyno tuner to flash your ecu, which will save hundreds of dollars.

This listing contains an ECU that was flashed and tuned on a Dyno.  The ECU is compatible with the 2008-2009 Suzuki GSXR 750. Included is 12oClockLabs Speedo Healer, AND a Woolich Suzuki GSX-R 750 Race Tools Package:

Woolich Racing Race Tools Package w/ Pit Speed Limiter

The package includes:

  • High quality strain gauge Quickshifter with digitally controlled pressure sensing that can be used in regular or race shift pattern.
  • Shift rod for standard shift configuration*
  • Suzuki Race Tools Harness Type 1 which allows the quickshifter to be plugged into the bikes wiring harness**
  • Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.

Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations. The quickshifter kills both fuel and ignition.

Launch Control allows you to configure Delay, Launch RPM, Ramp Time and Ramp RPM

Pit Speed Limiter allows you to set the RPM to limit the speed while riding through the pits.***

* Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length.

** This harness uses the stock Exhaust Valve plugs on the bike's harness, the stock Exhaust Valve should be removed from the bike and disabled in our software

*** Pit Speed Limiter harness sold separately - IT IS INCLUDED WITH THIS KIT (see below for description)


Pit Speed Limiter Harness

The Pit Speed Limiter harness is used with our Race Tools Package, it consists of a harness and water proof push button switch which allows you to limit the RPM of the bike in 1st gear while riding in the pits. You must have a Race Tool Package to use the Pit Speed Limiter Harness.

The Pit Speed Limiter harness also includes a stainless steel bracket used to mount the button on the bike's switch gear.