Bavaria carbide pitcher chisel

Carbide pitching chisel one sided lateral design with hammerhead oval shaft, cutting angle 80 deg. Extremely strong carbide blade.

Made in Germany for the StoneToolShop.

• Type 40mm 8mm tungsten carbide blade shaft 20/28mm 190mm long
• Type 50mm 8mm tungsten carbide blade shaft 26/33mm 190mm long
• Type 60mm 8mm tungsten carbide blade shaft 26/33mm 190mm long

Instructions

– On uneven surfaces it is advised to hit lightly until the full width of carbide is in contact with the stone
– Use the correct size
– Hit with the full width of the tool

Grinding advice

– Do not grind the carbide too sharp
– After grinding, give an edge to the corner
– Do not overheat. Do not quench
– Hold the chisel steady against the grinding disc

Always wear eye protection

https://youtu.be/g5WKgORJPTw