Do you need a muffler for this exhaust pipe? You can find it here... https://www.ebay.com/itm/285452015517
Or: eBay item number: 285452015517
Heavy-duty 1/4" mild steel flange. 1" Male ss / female ss Thread Pipe Fitting / female Stainless Steel 304. (Exhaust flange is mild steel) Tig Welded... Made in U.S.A.
Includes.
-2 stainless steel screws.
-2 Zinc Plated Lock washer,
-Gasket.
-Male 1" adapter (common water pipe 1" thread found at your local hardware store)
-Female 1" thread coupling.
Important, Keep in mind that 1" is not the actual thread size, it is measured by TPI number of threads per inch, read below for a better explanation. Also know that this adapter is only designed for use on the head of the engine as an exhaust, not on any other area of the engine.
Good for: Mini bikes, go karts, generators... multipurpose. This been tested on 8HP (301cc) OHV Predator, Predator 13 HP (420cc) Engine from harbor freight. -Works also: GX Honda 240, 270, 390 Briggs 1450 305cc, Lifan LF190F-BQ 15 HP 420cc. Made in U.S.A.
*Free shipping 1-4 business days. ON U.S.A.
*INTERNATIONAL CAN TAKE 30 DAYS!
Made in U.S.A.
We only ship to paypal confirmed address.
Florida residents pay 7% taxes.
Finding the Correct Pipe Thread Size
National Pipe Threads (NPT)
Pipe sizes do refer to physical dimensions, but the plumbing industry
standard for the sizes of pipe is not always as straight-forward as
measuring the pipe. Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care.
The "pipe thread size" as shown in column 3 of the table below is
measured and based on the inside of the pipe. But, to actually determine
the size of a pipe, the outside diameter of each pipe or fitting must
be measured and compared to the table for size identification. For
example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches.
Each thread size has a defined number of threads per inch (TPI). The
3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per
inch) and OD (outside diameter) of the thread are required for positive
identification of thread size because several sizes have the same TPI.
Please check my other Header (on other audition)