🇺🇸 Proudly Made in the USA 🇺🇸

Built with attention to detail and real fabrication experience right here in Florida, USA. Don’t confuse this exhaust with the lower quality imported copies on the market. Over the years, many overseas sellers have copied my designs, but the difference in quality, fitment, and craftsmanship speaks for itself. Please take a close look at the photos and customer feedback from thousands of satisfied buyers.

More than 10 years manufacturing exhaust systems for minibikes, go karts, mud motors, generators, and custom projects.

⚠️ Please Read Before Purchasing ⚠️

• This exhaust is made from raw mild steel and is NOT painted or coated. Surface rust may develop over time. If desired, you can apply high heat paint.
• Exhaust will become discolored from engine heat after use. This is normal.
• This exhaust is louder than the factory exhaust.
• Please carefully review all pictures and measurements before purchasing. Compare dimensions using a tape measure to make sure it clears your frame, fender, body panels, or other components.

MADE IN USA • HIGH QUALITY FABRICATION

Compatible with:
• Predator 212cc
• Predator 212 Hemi
• Tillotson 212
• BILT HARD 7HP 212cc
• Honda GX160
• Honda GX200
• DuroMax 7HP
• Powerhorse 208cc
• XtremepowerUS 7HP 212cc
• AlphaWorks 7HP 212cc

(Tested only on the engines listed above)

Material:
• Mild Steel / Uncoated Steel

Thread Information:
This exhaust has a 3/4" female NPT thread at the tip for installing a muffler or additional pipe. Please note that pipe thread sizes are nominal and do NOT represent the actual outside diameter measurement.

What’s Included:
• Exhaust pipe
• Gasket
• 2 lock washers
• 2 mounting nuts
• Muffler lock nut

(Muffler NOT included)

Florida residents pay 7% sales tax.

────────────────────────

Understanding NPT Pipe Threads

National Pipe Thread (NPT) sizes can be confusing because the stated size does not equal the actual outside diameter.

Example:
A 3/4" NPT thread actually measures approximately 1.050" outside diameter and uses 14 threads per inch (TPI).

To correctly identify pipe threads, you must compare:
• Outside Diameter (OD)
• Threads Per Inch (TPI)

Both measurements are required because some thread sizes may share the same TPI while having different diameters.

Please verify your thread size carefully before ordering.