Made in USA | Heavy-Duty Construction | 3/4" NPT Stainless Steel Female Thread
This exhaust header is designed for select Tecumseh Power Sport engines. Built from heavy-duty mild steel and equipped with a stainless steel threaded connection, it allows you to attach a compatible 3/4" NPT male-threaded muffler or other exhaust components.
Engine is NOT included.
Material: Mild steel, uncoated.
Threaded connection: 3/4" NPT female, stainless steel.
Finish: Bare metal, no paint or protective coating.
Manufactured in the USA.
IMPORTANT: This exhaust is NOT painted or coated. Surface rust may develop over time, especially when exposed to moisture. High-temperature exhaust paint is recommended if corrosion protection is desired.
The metal may also change color due to the high temperatures generated during engine operation.
Tested on:
Tecumseh Power Sport 5.0 HP
Tecumseh Power Sport 6.0 HP
Tecumseh Power Sport 6.5 HP
Not tested on other engines.
It may fit certain Briggs & Stratton engines with similar exhaust port configurations, but compatibility has NOT been verified or guaranteed.
IMPORTANT: Please carefully compare the exhaust flange shape, mounting hole spacing, exhaust port location, and all measurements shown in the listing photos before purchasing.
Engine horsepower alone does not guarantee compatibility.
1 Exhaust header with 3/4" NPT stainless steel female threaded connection.
Premium exhaust gasket.
Stainless steel mounting hardware.
Muffler and engine are NOT included.
If you install a muffler on this exhaust header, additional support is strongly recommended.
The muffler should be properly supported by a bracket connected to the engine or equipment frame.
Engine vibration combined with the additional weight of an unsupported muffler can place excessive stress on the exhaust flange, mounting bolts, and engine exhaust mounting points.
Failure to provide adequate support may cause bolts to loosen or break, damage the mounting threads, or cause cracking.
Do not allow a heavy muffler to hang unsupported from the exhaust header.
PLEASE READ BEFORE PURCHASING!
This exhaust features a 3/4" NPT FEMALE THREAD.
3/4" NPT is a nominal pipe thread size. It does NOT mean the actual threaded opening measures exactly 3/4" (0.750").
For reference:
Thread type: 3/4" NPT Female
Nominal thread size: 3/4"
Approximate female thread opening: 1.05", depending on where it is measured.
Thread pitch: 14 threads per inch (TPI).
Required mating connection: 3/4" NPT Male.
This is completely normal for standard NPT pipe threads.
Please refer to the NPT thread size chart included in the listing photos to better understand nominal pipe sizes and actual thread measurements.
Do not select a pipe thread size based only on a ruler measurement of the opening.
Please review ALL listing photos and measurements carefully.
Make sure the exhaust will clear surrounding components such as the frame, fuel tank, body panels, and other equipment.
This is an aftermarket exhaust component. Proper fitment and installation are the buyer's responsibility.
Thank you for choosing AR-EXHAUST, proudly made in the USA!