Triac Constant Current Dimming LED Driver
● Dimming interface: Triac/ELV, AC Push-Dim
● Apply to leading edge/trailing edge Triac dimmers and dimming system
● 1 channel constant current output, multi-current optional
● Built-in active PFC function: 0.95 Typ
● Connection of push switch for on/off and 0-100% dimming
● Over-load / Short circuit protection, recover automatically
● Class II design, SELV safety ultra-low voltage
● Suitable for indoor LED lighting application
Suitable
● Suitable for downlight, spotlight and decorative applications.
● Ofce / Commercial / Domestic Lighting, Hotels, Classrooms, Warehouse, Health care, Retail and Display.
● Use for retrot upgrades & new luminaire designs.
Triac dimming input
While connected with a Triac dimmer, such as Lutrom, Clipsal, Dynalite dimmer, different Triac dimmers from different suppliers may have different minimum
dimming levels which the driver can not be dimmed below. To dim to 1%, please make sure the dimmer supports 1% minimum dimming level.
AC Push-Dim input
The provided AC Push-Dim interface allows for a simple dimming method using commercially available non-latching(momentary) wall switchs.
● Short press:
Turn on or off light.
● Long press (1-6s):
Press and hold to step-less dimming,
With every other long press, the light level goes to the opposite direction.
● Dimming memory:
Light returns to the previous dimming level when switched off and on again, even at power failure.
● Synchronization:
If more than one LED driver are connected to the same push switch, do a long press for more than 10s,
then the system is synchronized and all lights in the group dim up to 100%.
This means there is no need for any additional synchrony wire in larger installations.
We recommend the number of LED drivers connected to a push switch does not exceed 25 pieces,
The maximum length of the wires from push to LED driver should be no more than 20 meters.
Note:
1. Triac dimming and PUSH dimming cannot be used at the same time.
2. If the product be used with the Push-Dim interface prior to using the Triac interface, the Triac dimming signal should change over 10% to return Triac control.
(First, adjust the Triac dimming signal to the maximum, and then turn it down so that the signal changes by more than 10%.)