Listing Includes 1 set of Arrma Infraction 6s V2 Rear Spoiler.

Custom Text: Max limit is 14 characters.


Note: Do not use Acetone or loctite on Polycarbonate  parts.

Screws: NOT INCLUDED.

You will need the following m3 screws for the Adjustable section of the spoiler.
5x M3 15mm Buttonhead or countersunk screws for Step 1 assembly.
3x M3  15/16mm Buttonhead or sockethead screws and 6x M3 washers for Step 2 assembly.
4x M3 15mm Countersunk Screws, Locknuts and washers for Final Step 4 assembly.



Please read below to choose the correct variation. Please message me if you are unsure. Thank you

Variations:


No screws Included.


3D printed in your material of choice.



Compatible with Arrma Infraction 1/7th scale only. ( Unsure/untested if Felony is compatible but it might be because they use the same base body)


Coloring -  PET is Quite Glossy. PCCF is Satin/Matte. 



Materials:
PET or Polycarbonate  Carbon Fibre (PCCF).
PET - Same material found in most plastic bottles like Coke etc. Temperature resistance is Good upto 75c. More Durable than PCCF. But Is very Glossy black.


Polycarbonate with 15% Chopped Carbon fiber (this is a lexan CF material) PCCF in short.

ePACF - Nylon and Carbon fiber blend.

PCCF is temperature resistant till 110c , Check link below for more info on mechanical properties.                                           

Nylon has Better mechanical and thermal properties (around 150c) and is more flexible.

ePHAT-CF is much much stronger, Almost similar to Aluminum with 100% infill and also has higher Temperature resistance (150c)

ASA has UV and weather resistance but has lower durability and Temperature resistance (Roughly 90C)


PCCF data sheet: PCCF PRO | PDF Host





Can be picked up as well.