Listing Includes 1 pair of Arrma Infraction 6s V2 Side skirts and accessories
Note: Do not use Acetone or loctite on Polycarbonate parts.
By Default You will get a Pair of rear winglets with your order.
Side skirts = Cnc Cut Polycarb, in either white or Translucent.
Other parts = 3D printed 95A TPU or PET Filament.
Screws: You will need the following m3 screws For the mudguards/rock deflectors: 8x12mm countersunk screws for each mudguard, 5x 10mm countersunk screws for side skirts and Another 4x12mm countersunk screws to fix the rear side to the chassis.
First install the side skirts onto the car.
Fix the mudguards to the side skirts.
Install the rear flaps/winglets with 4 screws (2 in each).
Please read below to choose the correct variation. Please message me if you are unsure. Thank you
Variations:
Both front and rear (2 pairs total) : Includes 1 pair side skirts , 1 pair Rear winglets, 1 pair of Front Rock deflectors/mudguards and 1 pair of Rear Rock deflectors/mudguards (all 3D Printed)
Side skirts only (No rock deflectors): Includes 1 pair side skirts (CNC cut PC) and 1 pair Rear winglets (3D Printed).
Front Rock deflectors/Mudguards only: 1 pair of Front Rock deflectors/mudguards and nothing else
Rear Rock deflectors/Mudguards only: 1 pair of Rear Rock deflectors/mudguards and nothing else
Full set with front wheel covers: Includes 1 pair side skirts (CNC Cut Polycarbonate) , 1 pair Rear winglets (3D Printed), 1 pair of front wheel covers (3D Printed), 1 pair of Front Rock deflectors/mudguards (3D Printed) and 1 pair of Rear Rock deflectors/mudguards (3D Printed), plu 12mm CSK 12.9 screws For Side skirts
Front rock deflectors/mudguards have a rough texture on the inside due to printing them hotter which makes them stronger. It is on the inside so once installed you wont see it. But you can sand it off if you wish.
You may add a pair of Front Rock deflectors/mudguards or a pair of Rear Rock deflectors/mudguards or Both ( 2 pairs of rock deflectors for both front and back) For additional cost.
Variation which Includes the Side skirts and rear winglets only and nothing else.
These may work with Arrma Felony 6s, but I have not Tested them personally.
No screws Included.
For side skirts you can use stock screws, For rear winglets and Mudguards, you will need your own Countersunk M3 screws.
3D printed OR CNC cut 3mm Polycarbonate.
CNC cut polycarbonate is only for Side skirts.
Compatible with Arrma Infraction 1/7th scale only. ( Unsure/untested if Felony is compatible but it might be because they use the same base body)
100% infill
Material for 3D printing - Either 95A TPU op Black PET Filament CNC Milled parts - White or Translucent Polycarbonate/Lexan.
Can be picked up as well. |