Pin Pitch is 0.635mm, 25mil, 'Imperial' (see other listing for 0.65mm 'metric') If not sure, go for metric.
Does your design end up looking like a birds nest?
Issues with reliability and signal noise due to trailing wires?
What is your time worth?? - Buy quality for faster, easier, cleaner prototyping!
“Prototype your own mini-module module – with prototype area for SMT and through-hole components”
Featured in an EEVBLOG Video:
Google Ayj65iqD00Q for a feature on this layout style. (Skip to 27:37)
My own video description:
Google ZUkgCZeQtMM for my a 3D model video and description
>> Other SMT packages available, check the shop <<
(Excess postage cost will be REFUNDED)
Seriously, this one does it all... Key features below...
- Accepts wide and narrow package types
- All SSOP pins connect to a dedicated pad on the prototype area
- Route 0V to micro pin using simple solder bridges. No wires
- All pins have a dedicated ‘no-fit’ for a decoupling capacitor. No wires
- 9 Additional 0.1" pin headers connected to ground (bottom row)
- Use the prototype areas for mounting crystals or any other housekeeping you care to think of Input signal conditional filer for all pins: can be configured as high pass, low pass clamps and more.. Use is optional. See images for annotated layout and circuit diagram
- Scope clip ground. Useful for checking high speed signal integrity / termination
- Full pin numbering on silkscreen
Without modification ALL pins of the device are connected directly to header. Use as a standard breakout board.
GEREROUS Multibuy discounts - up to 25% off
Package size
Will accept any wide or narrow body package of Pin Pitch 0.635mm (25mil, 0.025")
Post and packing:
Sent as a standard letter both domestically and internationally.
International Postage:
Standard postage is listed as 3-5 days to the US
Matrix measures 10.4 x 7.5cm.
Weight 20g
Ideal for
- Housekeeping: Add on-board decoupling caps, crystals, voltage references, diode clamps, TVS
- Analog low noise: Add inline filtering components close to IC pins
- Digital high speed: Add series or parallel termination close to the IC pins
Features
Prototyping area
Double sided!
Ideal for both SMT and through-hole components.
Extend your design with diodes, caps, regulators, XTALs and more
Plated vias allow signals to be passed from one side of the board to another
Easily route any of the 0.1" pin headers OR device pins directly to pads in the prototype area with the simple solder bridge links.
Pad pitch is 0.1"x0.05" or 100mil x 50mil
Ground distribution loop
Avoid the usual mess of ground connections..
Use a solder links to connect your incoming ground to the handy ground loop provided. Easily connect other pins to the ground loop.
There's even a scope clip area - no more clipping onto the pin headers, it never stays!
Flexible pin re-routing options
Each pin header has multiple solder bridge options to allow for routing to the prototype area - or to ground.
A single track cut option also allows the pin header and the IC pin to be routed separately.
There are too many use cases to list here - study the schematic and layout and you'll start to see the number of possibilities.
A filter on every pin!
And so much more besides.. Each pin has a provision for two 0805 or 0603 devices. One is located on the topside, the other on the underside. (The topside will also accept a through hole device)
These can be used for decoupling caps, current limiting series resistor, pull-up, pull-down, series termination, parallel termination, clamping, TVS, high-pass filter, low-pass filter - and many others besides. Again, study the layout to see the possibilities.
