ZADI PUSH LOCK in BLACK

Please see my shop category motorhome parts for other locks and latches

Compact flush design, the door handle pops out

Internal compression locking catch

Waterproof and corrosion protected

Complete with ZADI barrel and key set

Complete with neoprene gasket

Easy to fit with backing plate

Fits doors up to 50mm thick

Smooth operation

If you buy multiple locks we supply them keyed alike!

Dimensions

Barrel diameter: 3cm

Catch plate length: 6cm

Handle length: 8cm

Distance between screw holes: 5.5cm

This ZADI STS oval compartment lock is common to many mobile vehicles built in the U.K. such as the Swift Autotrail Bessacar Elddis and European marks such as Hymer Mobile. 

The Zadi STS lock operates on a 90-degree twist action. It has a compression action that means the door latch turns then pulls the door tight closed (to ensure a snug fit against a door seal.)

There is a backing plate included with the locking kit which is for optional use depending on the application of your lock. If the lock is being used on a thin metal sheet wall or similar, use the backing plate on the interior side of the wall to hold your screws in place. If the desired use of the lock is on a thick wood type material, the backing plate will not be necessary as the wall material will grasp the screws. 

 To operate put the key into the barrel, turn the key and the external handle pops out towards you making it obvious the door is now unlocked. A 1/4 turn on the handle and the door catch is released. To lock the door latch it is simply a case of twisting the locking catch and pushing the handle back flush into the mounting.

To replace your broken or sticking door you open your existing latch which reveals 2 external screws. Remove these. Undo the bolt on the rear of the Lock holding the catch on and remove the entire unit. To refit the new lock pass it through the door hole taking care to keep the supplied neoprene gasket in place. Using suitable screws (not supplied) secure the barrel in place, then fit the rear latch washer and finally the bolt and tighten. That’s it you're done!

The barrel as configured here has a gap of 50mm between the face of the outer latch and the face of the locking catch. These locks are often fitted on doors with a thickness less than 50mm because the manufacturers pack out or bend the internal catch plate to fit the locks reach

We are expanding sales from high end boat parts into the leisure market. We are experienced within the marine markets and were bringing this to our other passion. As avid travellers in our motorhome we try the products ourselves. If it's not of sufficient quality they don't make the shelves. SIMPLE !