IIL GPS Speedometer Antenna / Sender and receiver.
It can directly use for programmable speedometer sending unit.
This is upgraded version than V10
Power: 10-16 VDC
Output: pulse output, default is 16,000 pulse/mile, or 9,943 pulse/km. Adjustable from 5,000-19,000 pulse/mile, see instruction sheet for how to setup the pulse output. The signal output is for speedometer input, a standard square wave pulse signal, see signal screen shot below.
Indicate LED: green – signal is good, red – weak or no signal.
GPS signal update rate: 10/second, or 10 HZ.
Dimensions: 2.2” x 1.4” x 0.6”; Mounting holes distance: 1.7”; Cable length: 10’ (120”), mounting screws are not included.
Accuracy: 3M-CEP
In order to use this sender as a speedometer sender, your speedometer must can accept 5,000 to 19,000 pulses/mile. You don't have to know the speedo's input range, just connect the GPS sender with speedo and set the speedo to 100 MHP then it will work. See instruction for detail.
To quick test, just connect sender to +12V and ground (no gauge), the LED should turn to green in a couple minutes, otherwise the satellite signal is not enough.
Manual download here:
www.intindustry.com/files/GPS_Specification.pdf
For speedometer, see our store listing:
stores.ebay.com/industrialstuffs/4675295017
Pulse signal output (for speedometer input):
