— The revolutionized filtration technology ensures better flow rate and reduces most of the impurities in water.
— The natural coconut shell carbon with anti-bacterial material reduces chlorine-resistant cysts and 15 other contaminants.
COMPATIBLE FILTERS & FRIDGES
The LT800PWF refrigerator/icemaker water filter is compatible with the following refrigerators:
LG
LMXS30776S, LMXS30746S, LMXC24746S
LSC22991ST, LSXS26466S, LSXS26366S, LSXS26326S, LSXS26326W, LSXS26326B, LSXS22423S,
LSXS22423W, LSXS22423B, GF-5D712SL, GF5D712SL, GL-5D712SL, GF-AD701SL, GF-AD910SL, GF-5D712SL
The LT800PWF refrigerator/icemaker water filter is compatible with the following part numbers:
LG
LT800P, LT-800P
ADQ73613401
ADQ73613401-S
The LTF120F is compatible with the following LG refrigerator model numbers:
LFCS25663S, LFCS31626S, LFX25991ST, LFX25992ST, LFX28968D, LFX28968SB, LFX28968ST, LFX28968SW, LFX29927SB, LFX29927ST, LFX29927SW, LFX29927WB, LFX29937ST, LFX29945ST, LFX31915ST, LFX31925SB, LFX31925ST, LFX31925SW, LFX31935ST, LFX31945ST, LFX31995ST, LFX32945ST, LFX33975ST, LFXC24726D, LFXC24726S, LFXC24766*, LFXC24766S, LFXC24796D, LFXS24623B, LFXS24623D, LFXS24623S, LFXS24623W, LFXS24663S, LFXS27566S, LFXS29626B, LFXS29626S, LFXS29626W, LFXS29766S, LFXS30726B, LFXS30726S, LFXS30726W, LFXS30766D, LFXS30766S, LFXS30786S, LFXS30796D, LFXS32726S, LFXS32736D, LFXS32766S, LMX30995ST, LMX31985ST, LMXC23746D, LMXC23746S, LMXC23796D, LMXS27626S, LMXS27676D, LMXS27766S, LMXS30746S, LMXS30756S, LMXS30776D, LMXS30776S, LMXS30786S, LMXS30796D, LNXC23726S, LNXC23766D, LNXS30866D, LPCS34886C, LPXS30866D, LPXS30866S, LPXS30876D, LPXS30886D, LSC22991ST, LSFD2491ST, LSFD2591ST, LSFXC2476S, LUPXC2386N, LUPXS3186N, UPFXC2466S, GF-SD730SL, GF-D613PL, GF-D613SL, GF-SD730S, GF-5D712SL
INSTALLATION INSTRUCTIONS
Installation and replacement procedure for the LT800PWF fridge water filter:
1. If the top shelf, which is located below the water filter, is in the highest position, it will need to be removed.
This can be done in two simple steps:
• Tilt up the front of the shelf and lift it.
• Pull the shelf out.
2. Now, let's remove the old filter. Pull the water filter downward and turn it counterclockwise to pull it out.
Make sure to rotate the filter down completely before pulling it out of the manifold hole.
3. Take a new water filter out of its packaging and remove the protectiv cover from the o-rings.
With the filter tabs in the horizontal position, push the new filter into the manifold hole, rotate it up into place, and close the cover.
4. Now that the filter is replaced, dispense 2.5 gallons of water to remove trapped air and contaminants from the system.
Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF, rather then dispensing continuously.
If your model is equipped with a Water Filter Indicator on the display, press and hold the FILTER button or RESET button for approximately
5 seconds to reset the Filter Indicator
LT120F Installation Guide
Important: It is essential that operation, maintenance and filter replacement be carried out in accordance with manufacture's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void warranty.
The LT800PWF Water Filters Operating Specifications are as Follows:
• Flow Rate: 1.9 lpm
• Operating Temperature: min 0.6°C (33°F) / 37.8°C (100°F)
• Operating Pressure: min 20 (psi) / max 125 (psi)
• Function: Chemical and Mechanical Reduction
• Capacity: 757 litres (200 Gallons)
• Service Life: 6 months
• Dimensions approximately: 17.8cm (length) x 4.6cm (diameter)
Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
LT120F Specifications
• Replacement Part #: ADQ73214404
Dimensions
• Gross Width (inches): 3.3"
• Gross Depth (inches): 1.1"
• Gross Height (inches): 4.5"
• Gross CBM: 0.000264