All modifications must be installed by licensed mechanics and in compliance with your local modification regulations
Notice:
Pick up service is not available.
| Toll IPEC Mine Zone Black List (The Parcel Cannot Reach) | ||||||||
| 6443 | 6215 | 6427 | 6230 | 6440 | 6225 | 6436 | 6646 | 6646 |
| 6233 | 6640 | 6612 | 6507 | 6642 | 6390 | 6435 | 6621 | 6415 |
| 6431 | 6438 | 6718 | 6999 | 6437 | 6426 | 6753 | 6639 | 6346 |
| 6537 | 6722 | 6754 | 6638 | 6714 | 6430 | 6751 | 6762 | 6555 |
| 6705 | 6330 | 6721 | ||||||
Introduction
BFO coilovers are designed for those who want to change the old worn-out strut but get better handling without breaking your bank. It features with full length height adjustable, which brings you more performance on street use.
- For Subaru Impreza incl. WRX (GC, GF, GFC) 1992.11-2000.08
- Fit Chassis Code: GC5,GC6,GC7,GC8/GF5,GF6,GF8
Features
- 1. Self design structure and new manufacturing system to give more customers good coilovers.
- 2. Full length height adjustable---lower your car 1-3 inches to get performance ride
- 3. Independent Ride Height and Spring Pre-load Adjustments
- 4. Twin-Tube System for Comfortable Ride on Streets
- 5. Coated finish to avoid rust
- 6. Heavy Duty Steel Lower Mounts
- 7. Simple install, Easy to adjust.
- Damping adjustable: Not available
- Camber adjustable: Not available
- Height adjustable: Yes, lowering 25-75mm depending on the vehicle models
- Spring rate Front: 10 kg/mm (560 lbs/in)
- Spring rate Rear: 6 kg/mm (336 lbs/in)
- Spring length Front: 180 mm
- Spring length Rear: 180 mm
- Spring Preload advised: 7-10 mm
- Color: Red body with red spring
Package included
Complete coilovers 2 front and 2 rear as shown in the picture
Dimension
- Package size: 62*50*20 cm
- Weight: 25350 g
Important Notice
2. Please ensure all components are tightened with correct torque specifications (which can be found in the vehicle service manual)before and after installation. Any loose nuts, bolts, or locks will cause noise. Do check and tighten before serious problems happen.
3. Impact wrench is prohibited during the installation, it will loosen or damage the product.
4. Examine the clearance between tires and suspension. ( The minimum clearance should be 4mm, otherwise, you need to add wheel spacers. Caution: It is not sufficient with torsion beam trailing arm axles)
5. We suggest regular maintenance for the coil-over, spray with some WD40 every 3-4 months will keep it smooth and clean, which helps to extend the lifetime.
