Valve Cover Gasket  "ULTIMATE" Silicone

                   for 

SAAB & FORD V-4 ENGINES

"ULTIMATE"  SILICONE IS FIBERGLASS REINFORCED SILICONE 


**ATTENTION: If you are using thin steel valve covers, do not use this fiberglass reinforced gasket. Use the silicone gasket RG-8811077 instead.**

This may be the last gasket you will ever need to buy! 

   

·         A layer of fiberglass is centered between 2 layers of silicone

                 and gives the material extra stability and ultimate strength.

                 This is the absolute most stress that a material can resist

                 while being pulled or stretched which makes this

                 one tough gasket. 

 

             ·         Moreover, this material withstands temperatures from  

                 -100  to 500 degrees F.    It is resistant to deterioration  

                 by weathering and engine oil and remains flexible over

                 the temperature ranges.

 

          ·         Specifically, the gaskets are made from aerospace    

                      mechanical grade silicone and will not break down

                      and deform or crack up like cork or neoprene.            

 

          ·         Finally, and best of all, this is a reusable gasket.


FITS: 

  • SAAB
  • FORD V-4 ENGINES

Part number:   RG-8811077FR


Set of two (2)  "ULTIMATE" silicone gaskets

Gaskets have five (5) bolt holes and are 1/8" thick.

Reusable silicone gaskets.  


INSTALLATION INSTRUCTIONS:

  • Wash the cover and cylinder head surfaces with solvent.  
  •  Remove all traces of oil.
  • The gasket must be installed  DRY - do not use oil or lube of any type
  • TORQUE to 45-50 INCH pounds
  • Re-check torque, one time with engine hot.

DO NOT OVERTIGHTEN.   

If the gasket starts to bulge or squeeze out, then back off on the torque.


TO RE-USE GASKETS:  

Wash gaskets in hot soapy water.

Rinse and dry thoroughly.   

Re-install using the above installation  instructions.


Proudly made in the USA.

 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

USE CORK?   GET REAL!   REAL Gaskets that is…


REAL Gaskets Tennessee is a manufacturer of silicone rubber gaskets for 

aircraft, automobile, and motorcycle engines.


Our silicone rubber gaskets are made from aerospace mechanical grade 

AMS silicone, designed to withstand temperatures up 

to 400 degrees Fahrenheit and to last the life of the engine.   

  

Our gaskets seal uneven surfaces, eliminate corrosion  and 

are 100% reusable.


We manufacture valve cover gaskets for:


Aircraft: Continental, Franklin, Lycoming, Pratt & Whitney and 

Wright radial piston aircraft engines.


Automobiles: Ford, GM, Mopar, Porsche and VW automobile 

engines.


Motorcycles:  BMW, Harley-Davidson, Suzuki, BSA, Ducati, 

Moto Guzzi, Norton, Triumph, Saab and most other 

motorcycle engines.  


If you are tired of oil leaks, then a silicone rubber gasket is 

the only way to go, and REAL Gaskets Tennessee is 

the only place you can get “The Original” silicone rubber 

gasket.


MADE IN THE USA.