Nitronic® 60 Alloy 60 Sheet 4.75-51.31mm Plate S-21800 Cut to

Nitronic® 60 Alloy 60 Sheet 4.75-51.31mm Plate S-21800 Cut to

The tolerance for the width and length of a sheet metal blank is +/-2mm

Important: Sheet metal cuts are not suitable for decorative or visible areas. Scratches cannot be ruled out. Surface pure industrial quality. Cutting with guillotine shears. Not all sheets in protective film. Please ask separately if surface quality is relevant to you - we will try to find a solution for you.

  • TOP quality at fair prices
  • High-quality products made to measure and cut to size
  • Competent advice & service

Technical data:

Brand: Evek
Manufacturer number: Not applicable
Type: Sheet metal, plates
Material: Nickel alloy
Areas of application: Fasteners; pump shafts and rings; valve rod; pin and roller bearings
Characteristics: high wear resistance; good mechanical strength; excellent corrosion resistance; good hardness in the annealed state
Additional Information:
Length tolerance: +/- 2mm
US: S21800
Material: Nitronic 60

Description:

  • Production time - 5-7 working days.
  • Shipping preparation - 2-3 working days.
  • Please look at the FAQ.

Nitronic 60 is a high-alloy austenitic chromium-nickel steel with the addition of silicon (approx. 4%) and manganese (approx. 7%). The basis for this steel is iron. The chromium and nickel content is approx. 17% respectively about 8%. Alloy 218 has high wear resistance and good mechanical strength. The material is also very resistant to corrosion and offers good hardness in the annealed state.

Alloy 218 is used for:

  • fasteners;
  • pump shafts and rings;
  • valve rod;
  • Bolt and roller bearings.

Nitronic 60 has the following features:

  • high wear resistance;
  • good mechanical strength;
  • excellent corrosion resistance;
  • good hardness in the annealed condition.

documentation

Data sheet (German)
tungsten
designation
Important: Sheet metal cuts are not suitable for decorative or visible areas. Scratches cannot be ruled out. Surface pure industrial quality. Cutting with guillotine shears. Not all sheets in protective film. Please ask separately if surface quality is relevant to you - we will try to find a solution for you. high wear resistance; good mechanical strength; excellent corrosion resistance; good hardness in the annealed state Nitronic 60 is a high-alloy austenitic chromium-nickel steel with the addition of silicon (approx. 4%) and manganese (approx. 7%). The basis for this steel is iron. The chromium and nickel content is approx. 17% respectively about 8%. Alloy 218 has high wear resistance and good mechanical strength. The material is also very resistant to corrosion and offers good hardness