Brass round rod 2.0401 42-400mm Ms58 ​​round disc round rod rod 0.1-1 meter

Brass round rod 2.0401 42-400mm Ms58 ​​round disc round rod rod 0.1-1 meter

Important: the ends of sawn bars can be sharp/not deburred. The product photos show rods in the manufacturing length. The sawn bars delivered may differ.
The cut is not even. It deviates by +/- 3 mm on different sides.


Brass round rod with the material number 2.0401 is composed of copper (approx. 57-59%), lead (approx. 2.5-3.5%) and a remainder of zinc (approx. 36-40%) together. The material 2.0401 is easily hot-formable, but high hardness and strength are achieved through cold-forming. However, the cold formability itself is limited because of the risk of stress corrosion cracking. Brass round material also has very good machinability and is well suited for soft and hard soldering. Brass round steel CuZn39Pb3 is easy to punch and can only be polished mechanically (not suitable for electrolytic or chemical polishing).

Due to the lead content, brass round steel can only be welded to a limited extent. The material must not be welded using the following welding methods: manual arc welding, gas welding, TIG and MIG welding. Resistance welding is best suited for quality welding. Brass round material 2.0401 Ms58 ​​has a relatively low corrosion resistance. In particular, it is not resistant to various salt solutions, organic liquids and water.

Main Applications of Brass Rod:

  • fittings and faucet handles;
  • screws and nuts;
  • valve body;
  • Parts for electrical engineering and general mechanical engineering;
  • cable clamps;
  • Ballpoint pen tips.

Features of brass rod:

  • very good hot formability
  • very good machinability
  • suitable for soft and hard soldering
  • easy to punch and mechanically polish
  • only conditionally weldable (resistance welding is best recommended)
  • relatively low corrosion resistance to aggressive media (water, various salt solutions and organic liquids).
Brass round rod with the material number 2.0401 is composed of copper (approx. 57-59%), lead (approx. 2.5-3.5%) and a remainder of zinc (approx. 36-40%) together. The material 2.0401 is easily hot-formable, but high hardness and strength are achieved through cold-forming. However, the cold formability itself is limited because of the risk of stress corrosion cracking. Brass round material also has very good machinability and is well suited for soft and hard soldering. Brass round steel CuZn39Pb3 is easy to punch and can only be polished mechanically (not suitable for electrolytic or chemical polishing). Due to the lead content, brass round steel can only be welded to a limited extent. The material must not be welded using the following welding methods: manual arc welding, gas welding, TI