"STOP DOING CABLES NODDLES with your WEM Copicat v.3/4 extension".

I made this extension plate from my 3d printer and perhaps you will be interested doing this DIY mod using this kit (you will have to cut 10cm of the original cables and to be ready for an easy job with your soldering iron. Then, it's 100% reversible without any damage, if you've kept the orginial cables then you could reconnect them as stock configuration).

- the main plate is made from 3D printer (it has a folding door for your footswitch / replacement tapes, whatever) + 6 fixation screws

- a AC universal plug + 2 screws

- LED switch for power on/off the copicat or just stop the motor and the tape from spinning (resistor and cap included) 

- an output signal jack to amp

- a wet signal only to amp or footswitch jack

- a finger switch to bypass the echo

- a .pdf doc with all the info you need to connect the wires

The extension plate is fixed in place to the copicat using the two factory lateral screws (right side of the box). So no damage, it will be enough for normal use. If you have an intensive use of your copicat, you will have to add one or two additional screws (on the left side of the box where the kit have additional screws' legs on left side, just in case you want it stiffer).

The last picture is the first customer final result, thanks Matt for your nice feedback and this sexy Guild+amp setup.