• 1.Fitment:
  • For Honda Accord 1998-2002 L4 2.3L Front Left Manual Trans.
  •  
  • 2.Condition:
  • New, never-used, and in original, intact packaging
  •  
  • 3.What you need for installation:
    • cutter wheel
    • Death Hammer
    • drain pan
    • Sledgehammer or mallet
    • Long-handled diagonal cutting pliers
    • Pry bar or CV shaft remover
    • Ratchet and socket set
    • Access permission to maintenance manuals or maintenance databases
    • safety glasses
    • screwdriver
    • Torque wrench
    • Wheel block
    • Wrench kit
     
  • 4.The process of installation:

    • CV Axle Assembly For 1998-2002 Honda Accord L4 2.3L Front Left Manual Trans

    1.Fitment:

    For Honda Accord 1998-2002 L4 2.3L Front Left Manual Trans.

     

    2.Condition:

    New, never-used, and in original, intact packaging

     

    3.What you need for installation:

    • cutter wheel
    • Death Hammer
    • drain pan
    • Sledgehammer or mallet
    • Long-handled diagonal cutting pliers
    • Pry bar or CV shaft remover
    • Ratchet and socket set
    • Access permission to maintenance manuals or maintenance databases
    • safety glasses
    • screwdriver
    • Torque wrench
    • Wheel block
    • Wrench kit

     

    4.The process of installation:

    Step1.Make sure the vehicle is in Park or that it is in gear with the parking brake set. 


    Step2.Jack up the car and remove the wheel on the side where you will be working. 


    Step3.Locate the axle nut. It will be in the direct center of the hub or wheel assembly where you removed the wheel. 


    Step4.Some vehicles have a cotter pin to secure the axle nut. You’ll need to remove it using pliers to straighten the pin so it can be pulled out. You can spray it with lubricant if it’s rusted or stuck. 


    Step5. Remove the axle nut. In some cases, this step may require quite a bit of effort. If this is the case, your safety bet is to do this step before jacking the car up. 

     

    Step6.Carefully remove the bolts holding the brake caliper brackets in place and remove the calipers.

     

    Step7.Loosed the bolts holding the outer tie rod to the steering knuckle. If there’s another pin here, you’ll again need to use pliers to straighten it out.


    Step8.Remove the bolts holding the hub to the strut tower. You’ll need to keep the nut from turning while unbolting the hub. 


    Step9.Look further down the axle to see where it meets the transmission. Use your pry bar to pry the axle from the CV joint. You should be able to remove the axle at this point.


    Step10.Insert the new axle into the transmission where the old one was removed.

     

    Step11.Attach the new axle to the hub and begin replacing the bolts you removed earlier in the process:


    Step12.Replace the axle nut. Here, as before, use an impact wrench if you have one to safely tighten the nut. If you don’t have one, get the nut as tight as you can without yanking on it while it’s up on stands. 


    Step13.Replace the wheel and lower the vehicle.


    Item Specifics
    Brand 1autopowerstore
    Manufacturer Part Number 13197256
    OE/OEM Part Number 44306S4KA02
    Superseded Part Number 664155
    Fitment Type Direct Replacement
    Model Accord
    Engine L4 2.3L
    Note L4 2.3L & Manual Trans. only
    Interchange Part Number 66-4155
    California Prop 65 Warning Yes
    Compatible Makes Honda
    Year 1998-2002
    Location Front Left
    Placement on Vehicle Front, Left

    Payment
    We accept any payment which can be accepted be ebay.
     
    We only ship to verified order addresses. Please make sure your address is verified and up to date before sending payment. We cannot change any address after checkout has been completed. Please make sure you submit your correct address!
    Shipping
    1. Orders processed within 48 hours of payment verification.
     
    2. We only ship to confirmed Order addresses. 
     
    3. If you have not received your shipment within 10 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
    Returns & Refunds
    1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
     
    2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
     
    3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
     
    4. Return shipping is to be paid by the Buyer if the reason is "order by mistake" or "don't want it".
    Feedback

    We maintain high standards of excellence (five stars review) and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US.

    We request that you contact us immediately if you don't satisfied with our item or service, do not leave feedback before we solve your problem, so that we can satisfactorily address your concerns.

    Contact Us

    Do Check the compatibilities before placing order, or if you have any question in compatible chart, contact us first.

    Any question, please feel free to contact us.

    If there's any problem with your order, do contact us please.

    Shop Category
     Store Home
     Oxygen Sensors
     Window Regulator
     ABS Wheel Speed Sensor
     Headlight Assembly
     Window Switch
     Alternator
     Door Handle
     Cooling Fan
     Throttle Body
     Towing Mirrors
     Blower Motor
     Knock Sensor
     Ignition Coils
     Blower Resistor
     Head Gasket Set
     Wheel Spacers
     Water Pump
     Thermostat Housing
     AC Compressor
     Mass air flow sensor
     Condenser
     Wheel Hub Bearing
     Fuel Injectors
     Coolant Tank
     Brake caliper
     Fuel Pump Assembly
     Radiator
     Tire Pressure Sensor
     Dipstick
     Sun Visor
     Starter
     Engine Mount
     Fuel Tank Pipe
     Oil Pump
     Valve Cover
     CV Axle
     Wheel Hub Bearing Steering Knu
     Other
    Hot Item
    Excellent Delivery

    content_src_url

    Help & Info
    Payment Policy
    Shipping Policy
    Return Policy
    FAQ
    About Us
    New List Item
    CV Axle Assembly For 1998-2002 Honda Accord L4 2.3L Front Left Manual Trans

    1.Fitment:

    For Honda Accord 1998-2002 L4 2.3L Front Left Manual Trans.

     

    2.Condition:

    New, never-used, and in original, intact packaging

     

    3.What you need for installation:

    • cutter wheel
    • Death Hammer
    • drain pan
    • Sledgehammer or mallet
    • Long-handled diagonal cutting pliers
    • Pry bar or CV shaft remover
    • Ratchet and socket set
    • Access permission to maintenance manuals or maintenance databases
    • safety glasses
    • screwdriver
    • Torque wrench
    • Wheel block
    • Wrench kit

     

    4.The process of installation:

    Step1.Make sure the vehicle is in Park or that it is in gear with the parking brake set. 


    Step2.Jack up the car and remove the wheel on the side where you will be working. 


    Step3.Locate the axle nut. It will be in the direct center of the hub or wheel assembly where you removed the wheel. 


    Step4.Some vehicles have a cotter pin to secure the axle nut. You’ll need to remove it using pliers to straighten the pin so it can be pulled out. You can spray it with lubricant if it’s rusted or stuck. 


    Step5. Remove the axle nut. In some cases, this step may require quite a bit of effort. If this is the case, your safety bet is to do this step before jacking the car up. 

     

    Step6.Carefully remove the bolts holding the brake caliper brackets in place and remove the calipers.

     

    Step7.Loosed the bolts holding the outer tie rod to the steering knuckle. If there’s another pin here, you’ll again need to use pliers to straighten it out.


    Step8.Remove the bolts holding the hub to the strut tower. You’ll need to keep the nut from turning while unbolting the hub. 


    Step9.Look further down the axle to see where it meets the transmission. Use your pry bar to pry the axle from the CV joint. You should be able to remove the axle at this point.


    Step10.Insert the new axle into the transmission where the old one was removed.

     

    Step11.Attach the new axle to the hub and begin replacing the bolts you removed earlier in the process:


    Step12.Replace the axle nut. Here, as before, use an impact wrench if you have one to safely tighten the nut. If you don’t have one, get the nut as tight as you can without yanking on it while it’s up on stands. 


    Step13.Replace the wheel and lower the vehicle.

    Item Specifics
    Brand :1autopowerstore
    Manufacturer Part Number :13197256
    OE/OEM Part Number :44306S4KA02
    Superseded Part Number :664155
    Fitment Type :Direct Replacement
    Model :Accord
    Engine :L4 2.3L
    Note :L4 2.3L & Manual Trans. only
    Interchange Part Number :66-4155
    California Prop 65 Warning :Yes
    Compatible Makes :Honda
    Year :1998-2002
    Location :Front Left
    Placement on Vehicle :Front, Left

    Payment
    We accept any payment which can be accepted be ebay.
     
    We only ship to verified order addresses. Please make sure your address is verified and up to date before sending payment. We cannot change any address after checkout has been completed. Please make sure you submit your correct address!
    Shipping
    1. Orders processed within 48 hours of payment verification.
     
    2. We only ship to confirmed Order addresses. 
     
    3. If you have not received your shipment within 10 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
    Returns & Refunds
    1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
     
    2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
     
    3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
     
    4. Return shipping is to be paid by the Buyer if the reason is "order by mistake" or "don't want it".
    Feedback

    We maintain high standards of excellence (five stars review) and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US.

    We request that you contact us immediately if you don't satisfied with our item or service, do not leave feedback before we solve your problem, so that we can satisfactorily address your concerns.

    Contact Us

    Do Check the compatibilities before placing order, or if you have any question in compatible chart, contact us first.

    Any question, please feel free to contact us.

    If there's any problem with your order, do contact us please.


    All rights reserved.