This turntable has been tested by myself and seems to be in good mechanical condition. The turntable is missing a head shell and stylist. The dust cover does have scratches, scuff marks, and both the tabs are broken at the hinge points. The dust cover shell is in overall fair condition as it does not have any spider webbing, cracks, or major damage to the surface area besides the broken hinge points. The hinges are in good condition and have strong recoil resistance. When testing the item, I was not able to test the sound aspects of the turntable, but I did test all the button functions. The cueing button elevates the tone arm stabilizer and holds in an up or down position. When the turntable is spinning and the stop button is engaged, the needle will move upward and return to the tone arm rest position. The stop button will then move itself back into the left position and reset itself automatically once the tone arm reaches the rest position. When using the cueing button, you can have it in the upward position then move the tone arm over the platter to engage the rotation. You can then use the cueing button to lower the needle onto the platter, allowing the tone arm to traverse towards the center. The auto return will lift the tone arm upward and return it to the resting position. The pitch veritable speed controls are in working condition, and you can see that the platter rotation varies by the red light showing a change in the visual lines on the side of the platter. The option button for the 33 RPM and 45 RPM is in working condition as well as you can noticeably see a difference in the rotation speed of the platter between the two options. The outside surface of the turntable is in good condition with minor scuff or imperfections to the gray painted surface. The outside shell is also free from any cracks or major damage as well as there is no surface rust on the bottom metal plate. The four table supports still have the felt pads on the base and do have spring resistance as well as flexibility. The power cord is in good condition with no frays or cuts, and the AV Jacks are in good condition as well. These ground wire is in fair condition, but it looks like that it has a Fray or cut approximately 10 in from the end that you would connect to your ground point.