Introduction

Target Group

This document is for dentists and related personnel.

Range of Application

For the injection of oral anesthetics. It needs to be used in conjunction with card-style oral anesthetics and oral

disposable injection needles.

Oral Anesthesia Injector is suitable for the followingsituations

This product cooperates with the pre -installed card -type oral anesthesia to process conduction anesthesia and local

ifiltrtion anesthesia for oralcavity. When a periodic

anesthesia of the periodontal membrane, it can play a role inpromoting.

Contraindications

Intraligamentary injections are contraindicated in patients with active periodontal disease.

Notice:lf the productis not used in accordance withthe provisions of this manual, the manufacturer shall not be responsible for any direct effects or side effects caused. The sole responsibility lies with the medical staff.

Specifications:

·Type classification of electric shock protection: internal electric source. IEC standard 60601 type BF.

·Water resistance grade IPX 0. Keep dry.

·Working system: continuous operation

. No signal inputs

·No signal outputs

. No vibration prevention or cancellation

. Non AP/APG type

. Working environment: the equipment is applied in the general office environment.

. Power adapter input: AC 100-240V 50/60Hz Output: 5V DC. ·Working power: built-in lithium battery charging.

. Working voltage: DC 3.7v.

. Working current: 100mA.

Parameters of Oral Anesthesia Injector Product' s main performance parameters:

a) Classification by type of protection against electric shock: internal power supply equipment;

b) Classified according to the degree of protection against liquid ingress: IPXO

c) Classification by operating mode: continuous operation;

d) The rated voltage and frequency of the equipment: the host is dc.3.7V; the charging stand is d.c.5.0v;

e) No signal input, no signal output part;

f) for non-permanently installed equipment;

Working Environment

Environmental temperature: +5"C-+40"C Relative humidity: <80%RH

Air pressure: 700hPa 1060hPa (1 atm=1013.25hPa)

Storage and Transportation

This equipment should be handled carefully, kept away from shaking point, installed or stored at shadowy, dry, cool and ventilated places.

Don' store it together with articles that are combustible, poisonous, caustic and explosive.

This equipment should be stored in the environment where the relative humidity is 10% 93%, the atmosphere pressure is 70kpa to 106kpa and the Temperature is -10"C to +55"C. Excess impact or shake should be avoided during transportation.

Don' t mix it with dangerous articles during transportation.

Keep it away from sun or snow or rain during transportation.

Disinfection and Sterilization

The accessories of the oral anesthesia injector should be

disinfected/sterilized before use. It is recommended to follow the steps below:

Disinfection method of the main unit: first use gauze to dip a small amount of medical to carefully wipe the surface of the main unit, then dry it with clean gauze, and wipe and disinfect before each use;

The booster tube can be used again after high temperaturedisinfection.

Packing List

Main unit 1 pc

Boost pipes 8 pcs

Power wire 1pc