Please read before purchase. These are printed using a Laser printer and may take quite a while to be ready due to how time consuming the process is and other orders before yours.
I do not do rush orders and these are not the same quality as the sheet you get from professional miniature companies with industrial printers, decal printing is not an exact process and there may be a few differences from the mock design such as the colour being different, white being slightly transparent and also sometimes a printed blur, colour shift or offset to the icons, I can't control this and they are minor issues so please bear in mind BEFORE you purchase.
These are also /NOT/ pre-cut icons you have to cut around the icon yourself on the clear film part so there is an edge to work with.
I will not accept any cancellations for 'Won't arrive on time or changed mind on these items' If you have the put the wrong address in as well please just let me know where you'd like it sending instead of putting in a cancellation as these affect my seller ratings.
I also do not accept returns on these for any reason. Before you leave negative or neutral feedback for whatever reason please message me first as I will be able to help you with whatever the problem might be.
These are printed using a laser-printer with either white ink or a white underlay to make the icons show up over darker basecoats, due to this process there may be small dots or 'speckles' on the colours this is normal for this type of printing process which differs from the types of decals typically found in other miniature kits which are printed on a larger industrial scale.
There may also be a slight white offset under the design, this is uncommon but can still happen so please be aware of this as well.
If you purchase these to match another sheet you've bought before they may not match as printing colours tends to be different from batch to batch due to how toner printers work. It is more likely to match if you buy them at the same time but still there may be differences.
If you would like any different colours or different icons for your own faction or an existing faction / icon please reach out as I have many designs available to print and I can do custom orders without charging a design fee!
Icon sizes are all sized roughly for the faction / miniatures these are made for if you would you to know the specific sizes from a sheet on the menu or are looking for another type not listed please reach out.
Message me if you'd like more than more than one special sheet printed as I can do bulk deals!
These were printed on clear decal paper and you need to cut around the icon as close as possible to get them onto the shoulders or the surface area of the miniature otherwise the film will be too big I also recommend using the Microsol and Microset method
Not all detail may be printed on smaller icons such as holes on eyes or anything similar due to how toner ink works, they will still of course give the effect of the icon from afar and on a shoulder pad anyway.
Recommended Directions for use
1: Gloss Varnish the model or the area you would like to apply the transfer ( I use either Army Painter Gloss Varnish via brush or Hycote Clear Lacquer for spray)
2: Wait for the Varnish to dry
3: Cut around the decal as close as you can giving your self an edge around the icon (Do not cut the icon) these are not pre cut like regular transfers.
4: Apply a thincoat of Microset to the area of the model you will apply the decal
5: Soak the transfer in some lukewarm water for a few seconds
6: Slide the icon off the paper and onto the model
7: Leave this to set and dry fully
8: Apply a thin coat of Microsol letting it dry and applying more thin coats if needed to remove the edge
9: Seal in the model with a varnish of your choice