Green Stuff World Rolling Pin with Handle - Cobblestone Small

Textured Rolling Pin with handle capable of pressing a continuous repeated pattern on all kinds of sculpting putties, polymer clays and pastes. Made of clear PMMA plastic with amazing non-stick properties. The small size and the ergonomic handle make them an easy tool to use to create straight and curved lines to give more realism to the model or base. The textures are scalable to cover large surface areas.

• Roller Width: 4cm (1.5 inches)
• Roller Length with Handle: 14cm (5.5 inches)
• Diameter: 2.5cm (1 inch)
• Scale: 28-32mm (1/64-1/48)
• The textured rolling pins and their handles are presented unassembled.

USE INSTRUCTIONS 1 - Properly mix the putty/clay until ready according to the manufacturer's recommendations. 2 - Extend the putty/clay on a surface to be textured. For optimal results, make sure you have a smooth and even surface before impressing with the Rolling Pins. We recommend using a plain Rolling Pin for this. 3 - Depending on the type of putty/clay, it is advisable to wet the Rolling Pin to prevent any sticking. 4 - Slowly move the Rolling Pin applying equal pressure at all points for an even texture. 5 - Trim any excess putty/clay with a sharp knife. It is recommended to do this once it has dried to avoid any deformations in the putty/clay.

CARE INSTRUCTIONS:After working with the Rolling Pins, use a soft brush and plenty of water to clean off any residue on the rolling pins.

SAFETY:To ensure safety, children should be closely monitored by a responsible adult.