This is a USED Heater Control assembly for  both  the temperature of the water circulating in the heating / demisting system – and how much heat is directed towards demisting or heating.

We believe these are for a Later Series 3 and Defender

All the levers move easily over their full range, and click into position at either end of their travel.

They also stay where selected between the “full on” and “off” positions to allow the adjustment referred to above.

Included in the listing are the two finger grips. 

These Heater Control units are handed – this one is for RHD vehicles.

Shown in the listing is the allen key to tighten / loosen the tiny grub screw that secures the control wires.

The 2 grub screws are included in the listing, but the allen key is NOT included in the listing.

 The is a GENUINE  quality Land Rover part which operates well, and the photos show the levers in different positions.

The weight unpacked is 250g unpacked