- Perfect size to hit and store easy, best for 1:10 scale
- Available as just a frame, kit with deck, or Ready to Run (legs need to be bolted on)
- Adjustable legs-
40° is a good long kicker, 50° angle high jump launches well over 10'
high, 60° angle is great for low to medium
speed back flips
- Aluminum frame is easy to assemble, start feet hold ramp solid at any angle, leg feet keep it planted
- Read description below for more information.
This 2x3' - 24x36"ramp is a great in between to our other sizes. It
gives a wider target than the 2' while being easier to transport than
our 4' ramp. The 3' wide target is fairly easy to hit with speed as long
as you stay in-line with the car.
This design
is best for 1:10 scale, but can work up to 1:8 scale cars if you use it
in grass or pack dirt under the ramp deck. 2' long ramp x 3' wide gives a
nice transition and is small enough to still transport. It folds down
to 5" tall and is easy to transport to new spots. Aluminum frame is easy to assemble, start feet
hold ramp solid at any angle, leg feet keep it planted.
Assembly required
- Takes 30-40 min. - Frame bolts together with expanding tube inserts,
then clamp deck and use pilot holes in frame to drill and screw the top
deck to frame.
Ramp Deck
- 1 sheet of 1/8" Masonite (hardboard) is cheap and works good for 1:10 scale, get 2 sheets for 1:8 scale. Or upgrade to
1 sheet of 1/8" Lexan (polycarbonate) for a longer lasting deck. Lexan
will need to be chamfered for flat head screws to sit flush.
Masonite link - Click here - Home Depot 1/8" hardboard 2'x4'
Home Depot has pre-cut 2'x4' sheets at $7 for textured hardboard. Or a full 4'x8' sheet is only $13 and
they will cut it to size for free, which gives you extras.
Lexan link - Click here - Ebay 1/8" Polycarbonate 24"x48" Do NOT
get plexiglass (acrylic) - 24"x48" sheets are available on Amazon for
about $50, there are other places to buy from, this is just one example.
- Specs -
- Folds down to 5" high or 3" if you remove legs.
- Weighs 10# with 1 Masonite layer for 1:10 scale, or 13# with 2 layers for 1/8 scale.
- Three Settings - 40° is a good long kicker (20-40'), 50° angle
high jump launches well over 10' high, 60° angle is great for low to
med. speed back flips.
- 3/4"x .065 wall 6061 aluminum (also made in USA) frame is easy to assemble with expanding tube inserts
- Adjustable legs with 3D printed feet to keep ramp planted
- Start feet at base of ramp flip around to hold the start of ramp solid at higher angles
-
Masonite deck is weather resistant, give it a coat of paint for wet
climates. Use smooth side for mostly high speed, or textured side for
lower speed stunts.