- 1/4" mono FOUR conductor guitar output jack w/two nuts & one washer.
- two 12” hot & ground leads (Gavitt cloth covered pre-tinned 7 strand pushback wire 22 awg, WHITE for positive, BLACK for negative), heat shrinked over the two solder connections and at two places in wire length, wire twisted so as to NOT act as an antenna. (heat shrink colors may vary)
NOTE - a two wire lever connector is included FREE with this kit (see photo, grey with red and blue levers). It lets you cut the output jack white and black wires near their origin on the caps (between the two heat shrinks that I will put there), feed those wires in FROM OUTSIDE THE GUITAR INTO THE OUTPUT JACK HOLE into the control cavity and then connect them to the connector and then connect the same wires on the harness to the connector WITHOUT SOLDERING. You have to bare each wire about 3/4" by pulling back the cloth a bit.
This setup is ready to install in your guitar to replace your worn out import or Switchcraft jack!
The patented Pure Tone jack contains dual tension grounds and dual positive tips for optimal signal and lowest possible noise. 100% greater surface area at all contact points creates a more stable connection; as a result, high and low frequencies are greatly improved creating a much more balanced sound while eliminating frequency spikes. No more noise crackle caused by pressure grounds!
The Pure Tone jack allows for increased current handling at 500 volts for high current applications. Tensioned design locks cable securely in place while the increased metal mass carries more signal.
US Patent 9,680,264