High quality Titanium Gr5/TC4 Exhaust Stud for Toyota 1JZ / 2JZ engines, M10 x 1.25mm, 54mm long
Say goodbye to rusty exhaust studs for ever!
For 1JZ, 2JZ engine.
54mm long Ti stud with 4mm hex socket in one end.
Ideal length for use with 3mm thickness washer and flange nuts - available in the JASENGINE shop.
The material is grade 5 titanium, most widely used titanium alloy. Ti-6Al-4V also sometimes called TC4, Ti64 or ASTM (Titanium with 6% Aluminium and 4% Vanadium). It has excellent corrosion resistance to salt water, marine atmospheres and a variety of corrosive media temperatures below 300 ° C.
Strength is slightly less than an equivalent 10.9 steel fastener.
Stronger than 316 stainless steel fasteners.
When installing these exhaust studs it is important to apply either an anti-seize grease such as molybdenum disulphide or copper ‘slip’ grease.
Failure to apply anti-seize grease (on non-safety critical fixings) may cause the threads to gall on final torque of fastener and a seized/damaged thread.
For safety critical applications, do NOT apply anti-seize grease; apply a thread locking solution (e.g Loctite medium strength) on the threads before assembly.
Recommended maximum tightening torque for a Titanium M10 x 1.25 fastener ~38 Nm (Always check any particular torque specifications for your application).
Tip: Steel bolts with an 8.8 rating can be replaced with Gr5 Titanium versions, while bolts with a 10.9 rating can potentially be replaced with Gr5 Titanium versions depending on the intended use!
Technical details
Environment: High temperatures / wet &/or corrosive
Density: 4.43 g/cm3
Melting temperature: 1650 deg. C
Ultimate tensile strength: 135 KSI (950 MPa)
Yield strength (0.2% offset): 125 KSI (880 MPa)
Elongation: 15%
Hardness: Rc 34
Looking for other Titanium nuts and bolts? See my other listings for these and other interesting stuff!